Sony XAV-V630BT Operating Instructions 1 - Page 35

*1 Not supplied *2 Speaker impedance: 4 - 8 Ω × 4 *3 RCA pin cord (not supplied) *4 Depending on the type of car, use an adaptor for a wired remote control (not supplied). For details on using the wired remote control, see "Using the wired remote control" (page 36). *5 Whether in use or not, route the microphone input cord so it does not interfere with driving operations. Secure the cord with a clamp, etc., if it is installed around your feet. *6 For details on installing the microphone, see "Installing the microphone" (page 35). *7 Such as a portable media player, game console, etc. Making connections  To a common ground (earth) point First connect the black ground (earth) lead, then connect the yellow and red power supply leads.  To the +12 V power terminal which is energized at all times Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the +12 V power terminal which is energized when the ignition switch is set to the accessory position If there is no accessory position, connect to the +12 V power (battery) terminal which is energized at all times. Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the power antenna (aerial) control lead or the power supply lead of the antenna (aerial) booster It is not necessary to connect this lead if there is no power antenna (aerial) or antenna (aerial) booster, or with a manually-operated telescopic antenna (aerial). To AMP REMOTE IN of an optional power amplifier This connection is only for amplifiers and a power antenna (aerial). Connecting any other system may damage the unit.  To a car's illumination signal Be sure to first connect the black ground (earth) lead to a common ground (earth) point.  To the parking brake switch cord The mounting position of the parking brake switch cord depends on your car. Be sure to connect the parking brake lead (light green) of the power supply connection cable  to the parking brake switch cord. Parking brake switch cord Hand brake type Foot brake type  To the +12 V power terminal of the car's rear lamp lead (only when connecting the rear view camera) Memory hold connection When the yellow power supply lead is connected, power will always be supplied to the memory circuit even when the ignition switch is turned off. Speaker connection  Before connecting the speakers, turn the unit off.  Use speakers with an impedance of 4 to 8 ohms and with adequate power handling capacities to avoid damage. Monitor connection When installing a monitor for the rear seat, connect its parking brake switch cord to the ground (earth). Installing the microphone To capture your voice during handsfree calling, you need to install the microphone .  Clip (not supplied)   35GB