TEAC SR-L200I-W Owners Manual - Page 14

Listening to an External Source 1 Connect the PHONES jack (audio output jack) of a portable audio player to the AUX IN jack of the SR­ L200i using the supplied stereo mini plug cable. 3 Play the source, and adjust the volume using the VOLUME button of the SR-L200i and of the audio player. You can use this way of connection to listen to an iPod that has no Dock connector or that has, but an appropriate Dock adapter is not available. When using the PHONES jack of your mini player, you must adjust the volume of the mini-player or you may hear no sound from your SR-L200i. 2 Press the AUX button. < Turning the volume of the mini player up too high may cause the sound from your SR-L200i to be distorted. If this is the case, reduce the volume of the mini player until the distortion stops and then adjust the volume level of the SR-L200i to a comfortable listening level 26 Troubleshooting If you have problems with your system, look through this chart and see if you can solve the problem yourself before calling your dealer or TEAC service center. General iPod Player Cannot insert the iPod. e Check the dock adapter. e Remove dust or obstacles from the Dock connector of the SR-L200i and the iPod, and insert the iPod again. No power e Check the connection to the AC power supply. Check and make sure the AC source is not a switched outlet and that, if it is, the switch is turned on. Make sure there is power to the AC outlet by plugging another item such as a lamp or fan into the outlet. No sound from speakers. e Select the source by pressing the TUNER, iPod or AUX button. e Adjust the volume. e Pull out the headphone's plug from the PHONES jack. eIf the MUTING indicator lights on the display, press the MUTING button. Will not play. e Remove the iPod from the dock, wait a few seconds, and insert it again. e Software update may solve the problem. Visit the Apple website and download the latest iPod Software. Cannot operate the iPod. e Set off the HOLD switch of the iPod. Tuner Cannot listen to any station, or signal is too weak. e Tune in the station properly. e Rotate the FM or the AM antenna until you get stations clearly. The sound is noisy. e The unit is too close to a TV or similar appliances. Install the unit apart from them, or turn them off. Remote control doesn't work. e Press the STANDBY/ON switch to turn the unit on. e If the battery is exhausted, replace it with a new one. e Use remote control unit within the range (5 m) and point at the remote sensor on the front panel. e Clear obstacles between the remote control unit and the main unit. e If a strong light is near the unit, turn it off. Though the broadcast is stereo, it sounds monaural. e Press the FM MODE button. If normal operation cannot be recovered, unplug the power cord from the outlet and plug it again. 27 ENGLISH