TRENDnet AC1200 User's Guide - Page 11

TRENDnet User's Guide Network LAN Setting TEW-800MB Subnet Mask The subnet mask of the local area network; it should be the same as your router has. Default Gateway The IP address of the router on the local area network. Wireless Basic Wireless Setting LAN Connection Type Choose "Static IP (fixed IP)" if your router does not support DHCP or if for any other reason you need to assign a fixed address to the media bridge. In this case, you must also configure the following fields. IP Address It's the IP address of this Media Bridge on the local area network. Assign any unused IP address in the range of IP addresses available from your network. For example, 192.168.10.110 is the default. If you chose the DHCP client setting: After the connection between the TEW-800MB and your router is successful, the IP address of the TEW-800MB will change to a different IP from the default, 192.168.10.110. To find out the IP assigned to the TEW-800MB from your router, please check the DHCP client (device) list on your router and then type in the assigned IP of the media bridge from your router in the browser to access to the management interface of the media bridge. You may type in the http://tew-800mb in your browser to access to the management interface of the media bridge. © Copyright 2013 TRENDnet. All Rights Reserved. You can choose Wi-Fi Protected Setup™ (WPS) or Manual setup. In WPS mode, the TEW-800MB may connect to your router on the default 2.4GHz band. Under Manual setup, you can choose a 2.4GHz or 5GHz Wi-Fi connection by entering the SSID and security key of your router, then click Save Settings. 2.4 GHz 802.11 B/G/N mixed mode This wireless mode works in the 2.4GHz frequency range and will only allow the use of wireless B/G/N client devices to connect and access the TEW-800MB, at 11Mbps for wireless B, 54Mbps for wireless G, and up to 150Mbps transmitting/300Mbps receiving for wireless N. 11