Toro 20330 Operation Manual - Page 10

Cutting Leaves - lawn mowers

Get Toro 20330 - Low Wheel Walk Power Mower PDF manuals and user guides
UPC - 021038203300
View all Toro 20330 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

- Walk at a slower pace while mowing. - Raise the cutting height on your mower. - Cut the grass more frequently. - Overlap cutting swaths instead of cutting a full swath with each pass. - Set the cutting height on the front wheels one notch lower than the rear wheels. For example, set the front wheels at 2-1/8-inch (54 mm) and the rear wheels at 2-1/2 inches (64 mm). Cutting Leaves • After cutting the lawn, ensure that half of the lawn shows through the cut leaf cover. You may need to make more than one pass over the leaves. • If there are more than 5 inches (13 cm) of leaves on the lawn, set the front cutting height one or two notches higher than the rear cutting height. • Slow down your mowing speed if the mower does not cut the leaves finely enough. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
–
Walk at a slower pace while mowing.
–
Raise the cutting height on your mower.
–
Cut the grass more frequently.
–
Overlap cutting swaths instead of cutting a full
swath with each pass.
–
Set the cutting height on the front wheels one
notch lower than the rear wheels. For example,
set the front wheels at 2-1/8-inch (54 mm) and
the rear wheels at 2-1/2 inches (64 mm).
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need to
make more than one pass over the leaves.
•
If there are more than 5 inches (13 cm) of leaves
on the lawn, set the front cutting height one or two
notches higher than the rear cutting height.
•
Slow down your mowing speed if the mower does
not cut the leaves finely enough.
10