Toro 20330 Operation Manual - Page 4
Setup - manual
UPC - 021038203300
View all Toro 20330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Setup Manufacturer's Mark 1. Indicates the blade is identified as a part from the original machine manufacturer. Important: Remove and discard the protective plastic sheet that covers the engine. 1. Installing the Handle Procedure 94-8072 1. Lock 112-8867 2. Unlock Folding or unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or unfolding the handle. • If a cable is damaged, contact an Authorized Service Dealer. 1. Remove the handle knobs from the mower housing (Figure 3). Important: Route the cables to the outside of the handle knobs as you install the handle. 114-7982 1. Warning-read the Operator's Manual. 2. Thrown object hazard-keep bystanders a safe distance from the machine. 3. Cutting/dismemberment hazard of hand or foot, mower blade-remove the ignition key and read the instructions before servicing or performing maintenance. 4. Cutting/dismemberment hazard of hand or foot, mower blade-stay away from moving parts. 5. Cutting/dismemberment hazard of hand or foot, mower blade-do not operate up and down slopes; operate side to side on slopes; stop the engine before leaving the operating position; and look behind you when backing up. Figure 3 2. Move the handle to the operating position. 3. Install and tighten the handle knobs that you removed in step 1 (Figure 3). 4