Toshiba MET400-PK User Guide - Page 60

Photos and your gigabeat® Retrieving photo data from a digital camera 59 NOTE ❖ Charge the gigabeat® sufficiently before connecting it to the digital camera. If data is transferred from the digital camera while the gigabeat® battery power is low, data recorded in the gigabeat® may be damaged when the battery runs out in the middle of transfer operation. ❖ Do not unplug or plug the USB cable while the gigabeat® is processing. ❖ Depending on the type of the digital camera, you may need to switch the camera to an appropriate mode beforehand so that it can connect to a computer, etc. ❖ If the gigabeat® has not enough available space, only the amount of photo data that can be stored in the available space will be transferred. ❖ Do not use a USB hub to connect the digital camera and gigabeat®. ❖ Due to the limitation imposed by the gigabeat® USB bus power-supply function, some digital camera models may not be connected to the gigabeat® or may cause the USB function of the gigabeat® to be disabled temporarily. In this case, remove the digital camera, turn OFF the gigabeat® power, and then turn on the power again. ❖ The gigabeat® can only recognize one folder in the connected digital camera. If the digital camera has two or more storage folders, only one will be recognized. Deleting photo data You can delete photo data retrieved directly from the digital camera, without connecting the gigabeat® to your computer. 1 Select my pictures on the start screen, and press the OK button. 2 Press the Left or Right button on the PlusPad™ to select view by folder.