Toshiba SD-R6112 User Manual - Page 5

Setup - Sd-r6012 - sd driver

Page 5 highlights

SETUP - SD-R6012 Toshiba recommends that only trained professionals install this DVD Rewriteable drive into your laptop/notebook. Installation Notes • The SD-R6012 DVD Rewriteable drive has no jumpers that need to be set • Mounting orientation: 15º (horizontally), 15º vertically (volume control in down position), 30° (drive with volume control in up position). • When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive. • When mounting drive, the tightening torque of the four screws must be even. Recommended screw tightening torque is 2N • For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm should be left in all directions. Software Driver Toshiba's SD-R6012 drive does not require any unique device drivers for Windows '98/2000/XP/NT. After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the ATAPI driver from our web site. 3

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13

3
SETUP – SD-R6012
Toshiba recommends that only trained professionals install this DVD Rewriteable drive into your
laptop/notebook.
Installation Notes
The SD-R6012 DVD Rewriteable drive has no jumpers that need to be set
Mounting orientation: 15
º
(horizontally), 15
º
vertically (volume control in down position), 30°
(drive with volume control in up position).
When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive.
When mounting drive, the tightening torque of the four screws must be even. Recommended
screw tightening torque is 2N
For clearance around the front bezel, it is recommended that a clearance of more than 0.8mm
should be left in all directions.
Software Driver
Toshiba's SD-R6012 drive does not require any unique device drivers for Windows '98/2000/XP/NT.
After installing your drive and re-booting, your system should recognize your drive. Win '98/2000/XP/NT
Operating Systems support all Toshiba's ATAPI drives natively. If you prefer using DOS, download the
ATAPI driver from our web site.