Toshiba TDP-EW25 User Manual - Page 12

Operating a computer using the remote control A computer can be operated using the projector's remote control. This function is available on any computer with the Windows® 98/98SE, Windows® Me, Windows® 2000, Windows® XP, or Windows Vista™ OS, that is equipped with a USB port which can support USB1.1 (The mouse remote control receiver is also supported on OS 9 or OS X for the Macintosh). However, please note that Toshiba does not guarantee the operation of all computers. 1 Connecting a computer Connect the mouse remote control receiver (supplied) to a computer. To USB port The remote control may fail to operate if the mouse remote control receiver is exposed to bright sunlight or fluorescent lighting. In such a case, change position or direction of the mouse remote control receiver and retry. Mouse remote control receiver 2 Operating a computer Operate remote control's buttons towards the mouse remote control receiver. Q Moving the mouse pointer Press the mouse control button in the direction you wish the mouse pointer to move, then press. Q To left click Press the L-CLICK button. Q To right click Press the R-CLICK button. Q To drag and drop Holding down the L-CLICK button, move the mouse control button until the mouse pointer is over the desired location, then release the L-CLICK button. Q Using the computer's page up [] and down [] function Press the PAGE+ and PAGE- buttons to switch PowerPoint® slides. Remote Control Front Remote Control Rear Mouse control PAGE - R-CLICK L-CLICK PAGE + 22 Placement Placement Styles As shown in the figures below, this device can be placed in 4 different styles. The factory setting is "floor-mounted front projection." Set the [Projection mode] in the Default setting 2 menu p.44 , in accordance with your needs. Floor-mounted front projection Floor-mounted rear projection Ceiling-mounted front projection Ceiling-mounted rear projection WARNING • Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean or replace the lamp in a high location by yourself may cause you to fall, resulting in injury. • If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident. • If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact. Projection Distance and Size Use the figures, tables, and formulas below to determine the projection size and projection distance. (Projection sizes are approximate values for full-size picture with no keystone adjustment.) Screen As seen from above 90° a is the distance (mm, feet) between the lens and the screen, and corresponds to a range of 498 mm (1.63 ft.) to 1526 mm (5.01 ft.). a = 0.000625 × projection size (inches)2 + 12.9175 × projection size (inches) - 32.85 As seen from the side Lens center 90° a Projection size 41 inches 50 inches 60 inches 80 inches 100 inches 120 inches Projection distance a 498 mm (1.63 ft.) 615 mm (2.02 ft.) 744 mm (2.44 ft.) 1005 mm (3.30 ft.) 1265 mm (4.15 ft.) 1526 mm (5.01 ft.) 23 Preparations