Tripp Lite SMX500RT1U Owner's Manual for SmartPro Rack 932259 - Page 4

201109267 93-2259-EN.qxd 10/21/2011 3:39 PM Page 4 Mounting (Rack) continued 2-Post (Telecom) Mounting Mount 1U UPS models in 2-post racks with user-supplied hardware following the procedure below. If you mount 2U UPS models in 2-post racks, they require the addition of a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKIT, sold separately). See Installation Kit owner's manual for installation procedure for 2U UPS models. 1 Attach mounting ears A to the front mounting holes of your UPS B using the screws provided C . The ears should face backward. B C A 1 2 Using an assistant if necessary, lift your UPS and attach it to the rack by passing the screws, nuts and washers provided D through its mounting ears and into the rack rails. D 2 Mounting (Tower) Mount all UPS models in an upright, tower position using included hardware. The user must determine the fitness of hardware and procedures before mounting. All UPS Models Stand your UPS on its side with the LED/Control panel at the top. Attach one rack mounting ear A to each side of the UPS using included screws. A 2U UPS Models Only Rotate the LED/Control panel to view it easier while the UPS is tower mounted. Insert a small screwdriver, or other tool, in the slots on either side of the panel. Pop the panel out; rotate it; and pop the panel back in place. 4