Troy-Bilt CS 4325 Operation Manual - Page 12
Cleaning The Reduction Chamber - shredder
View all Troy-Bilt CS 4325 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Cleaning The Reduction Chamber 3. WARNING: The impeller's shredder blade and chipper blades are sharp. Wear leather work gloves 4. to protect your hands when cleaning out the reduction chamber. 5. If the reduction chamber becomes clogged with debris, the shredder screen can be pivoted upward so that you can clean the surrounding area. To do so, proceed as follows: 1. Stop engine, disconnect spark plug, and make certain the 6. chipper shredder has come to a complete stop. WARNING: The muffler and surrounding area will be hot if the engine has been running. Use caution 7. and protect your hands if working near the muffler. Remove the hairpin clip from the clevis pin which extends through the housing and shredder screen. See Figure 6-1B. Remove clevis pin. Pivot the shredder screen upward. See Figure 6-1C. Clean the surrounding area by scraping away debris. Confirm that the spark plug wire is disconnected and away from spark plug. Pull on the starter rope two-to-three times to purge any remaining debris from the reduction chamber. When the area is cleaned, pivot the shredder screen downward and re-secure with the clevis pin and hairpin clip removed earlier. Reattach the debris collection bag to the chute deflector, if desired. 2. If attached, remove debris bag. Remove the two wing knobs on either side of the chute deflector and pivot the chute deflector upward. See Figure 6-1. C A B Figure 6-1 12 Section 6- Maintenance & Adjustments