Uniden ATLANTIS 270 English Owner's Manual - Page 16

setting UP tHe HarDWare - parts

Page 16 highlights

Weather mode with Triple Watch or Dual Watch If you activate Triple Watch while operating Monitoring Weather Channel WX08 in weather mode, the radio checks channels 9 and 16 every two 09 16 09 16 09 16 seconds; with Dual Watch turned on, the radio only checks Every few seconds, the radio checks channel 9, then c.hannel 16. with Triple Watch on channel 16. Setting Up the Hardware Install the Battery Pack Your radio uses the supplied Lithium Ion battery pack. To install the Lithium Ion battery pack: 1. Remove the belt clip if installed. 2. Use a screwdriver to turn the battery compartment screw counterclockwise and then lift up and remove the battery cover. 3. Line up the new battery's connector with the jack inside the battery compartment (the connector only fits one way). 4. Push the connector in firmly. Tug on the battery wires gently to make sure you have a good connection. 5. Before replacing the battery cover, check the rubber seal located on the under side of the cover; make sure that the seal is set in the groove and that there is no foreign matter under the seal. ## Note: If the rubber seal appears warn, nicked, or dried out, you must replace it. New seals are available through the Parts Department (see the cover page for contact information). 6. Replace the battery compartment cover. Tighten the screw securely. E-12 Uniden Atlantis 270 Radio Owner's Manual

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

E-12
Uniden Atlantis 270 Radio Owner’s Manual
Weather mode with Triple Watch or Dual Watch
If you activate Triple
Watch while operating
in weather mode, the
radio checks channels
9 and 16 every two
seconds; with Dual
Watch turned on, the
radio only checks
channel 16.
setting UP tHe HarDWare
iNSTALL ThE BA±ERy PAcK
Your radio uses the supplied Lithium Ion battery pack. To
install the Lithium Ion battery pack:
1.
Remove the belt clip if installed.
2.
Use a screwdriver to turn the battery compartment screw
counterclockwise and then lift up and remove the battery
cover.
3.
Line up the new battery’s connector with the jack inside
the battery compartment (the connector only fits one
way).
4.
Push the connector in firmly. Tug on the battery wires
gently to make sure you have a good connection.
5.
Before replacing the battery cover, check the rubber seal
located on the under side of the cover; make sure that
the seal is set in the groove and that there is no foreign
matter under the seal.
#
noTE: if ThE RubbER SEAL AppEARS wARN, NIcKEd, oR dRIEd ouT,
you muST REpLAcE IT. nEw SEALS ARE AvAILAbLE ThRouGh ThE PARTS
DEpARTmENT (SEE ThE covER pAGE foR coNTAcT INfoRmA°oN).
6.
Replace the battery compartment cover. Tighten the
screw securely.
09
16
Every few seconds, the radio checks
channel 9, then c.hannel 16.
with Triple Watch on
09
16
09
16
Monitoring Weather Channel WX08