Uniden HOMEPATROL-2 Owner s Manual - Page 34
Battery And Power Information
View all Uniden HOMEPATROL-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
BATTERY AND POWER INFORMATION HomePatrol‐II comes with a mini‐USB to USB cable to connect your HomePatrol‐II to your computer or to an AC power adapter (not included). In addition, HomePatrol‐II also requires four (4) AA Alkaline or NiMH rechargeable batteries (one set of four NiMH rechargeable batteries is included with the unit). NOTE: These rechargeable batteries do not require a recharging station; you can leave them in the unit and select to recharge them when HomePatrol‐II is connected to external power. Installing the Batteries From the back of the HomePatrol‐II unit: 1. Slide the battery cover lock to the right to unlock the battery cover. 2. Press and push down on the center to disengage the battery cover. 3. Insert the batteries according to the directional label inside. 4. Replace and relock the battery cover. Battery Compartment Lock/Unlock Compliance Label Antenna Screw NOTE: Battery cover removed. Caution Label microSD Card Recharging the Batteries The rechargeable batteries included with HomePatrol‐II are 2300 mAh. You can set how long it will take to recharge a battery from a drained state to a fully charged state through the Set Charge Time menu on the Advanced Menu. The maximum recharge time HomePatrol accepts is 14 hours. Then, when you connect HomePatrol‐II to a power source and allow battery charging, HomePatrol‐II uses that data to charge the batteries. When battery power drops below a certain level, a Battery Low pop‐up displays the following message: "Batteries are low. Replay and Recording disabled. Connect external power to prevent data loss." 28