Via EPIA-NX15000G User Manual - Page 22
IDE Connector
View all Via EPIA-NX15000G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Chapter 2 CONNECTORS IDE Connector: IDE The mainboard has an Ultra DMA 133/100 controller. You can connect up to two IDE devices in any combination. 1 If two drives are connected to a single cable, the jumper on the second drive must be set to slave mode. Refer to the drive documentation supplied by the vendor for the jumper settings. Pin Signal 1 #IDE_RST 3 PD_7 5 PD_6 7 PD_5 9 PD_4 11 PD_3 13 PD_2 15 PD_1 17 PD_0 19 GND 21 #PD_REQ 23 #PD_IOW 25 #PD_IOR 27 #PD_RDY 29 #PD_ACK 31 PD_IRQ15 33 PD_A1 35 PD_A0 37 #PD_CS1 39 #HD_LED1 Pin Signal 2 GND 4 PD_8 6 PD_9 8 PD_10 10 PD_11 12 PD_12 14 PD_13 16 PD_14 18 PD_15 20 NC 22 GND 24 GND 26 GND 28 PRIMARY 30 GND 32 NC 34 IDE_DMADET 36 PD_A2 38 #PD_CS3 40 GND 10 Downloaded from www.Manualslib.com manuals search engine