ViewSonic SC-Z55 SC-Z55 User Guide (English) - Page 18

Step 3: Store Screws inside the Bracket, Step 4: Remove Screws from the Bracket

Get ViewSonic SC-Z55 PDF manuals and user guides View all ViewSonic SC-Z55 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 18 highlights

Setting Up Your SC-Z55 Positioning Your SC-Z55 Step 3: Store Screws inside the Bracket To store screws inside the bracket, please do the following: NOTE • It's highly recommended to store screws inside the bracket when not needed to prevent them getting lost. 1. Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth with the screw storage side upward. 2. Place the screw upon its storage space, and push the screw into the space with your finger until it clicks into place. For the smallest-size screw, use the tip of a screwdriver instead to push the screw. NOTE • Please refer to the figure and descriptions in "Step 2: Understand Your Stand / VESA Mount Kit for SC-Z55"5" for the correct storage space of each screw. Step 4: Remove Screws from the Bracket To remove screws stored inside the bracket, please do the following: 1. Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth with the screw storage side downward. 2. Insert the tip of a screwdriver into the square holes to remove the desired screws from the bracket. Square Hole 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
Setting Up Your SC-Z55
Positioning Your SC-Z55
10
Step 3: Store Screws inside the Bracket
To store screws inside the bracket, please do the following:
NOTE
•
It’s highly recommended to store screws inside the bracket when not needed
to prevent them getting lost.
1.
Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth
with the screw storage side upward.
2.
Place the screw upon its storage space, and push the screw into the space with your finger until it clicks
into place. For the smallest-size screw, use the tip of a screwdriver instead to push the screw.
NOTE
•
Please refer to the figure and descriptions in “Step 2: Understand Your Stand / VESA
Mount Kit for SC-Z55”5” for the correct storage space of each screw.
Step 4: Remove Screws from the Bracket
To remove screws stored inside the bracket, please do the following:
1.
Place a sheet of paper or a piece of cloth on a flat surface, and then put your bracket on that paper or cloth
with the screw storage side downward.
2.
Insert the tip of a screwdriver into the square holes to remove the desired screws from the bracket.
Square Hole