ViewSonic VG175 User Guide - Page 5

Quick Installation E N G L I S H 1 Connect video cable Make sure both the ViewPanel® and computer are powered OFF. • Rotate the ViewPanel 90° clockwise (to allow easier connection of cables). • Connect the video cable to the computer, then to the ViewPanel. Macintosh® users: Models older than G3 require a Macintosh adapter. Attach the adapter to the computer and plug the video cable into the adapter. To order a ViewSonic® Macintosh adapter contact ViewSonic. See "Customer Support" on page 15. 4 Install INF and ICM files (1) Insert the ViewSonic Wizard CD-ROM into your computer's CD-ROM drive. NOTE: If your computer does not have a CD-ROM drive, see Customer Support in this user guide. (2) Wait for the CD-ROM to auto-start. NOTE: If your computer does not auto-start: double-click on the CD-ROM icon in the Windows Explorer, then double-click on install.exe (3) Follow the on-screen instructions. 5 Windows users: Set the Timing Mode (resolution and refresh rate) Example: 1280 X 1024 @ 60 Hz. For instructions on changing the resolution and refresh rate, see the user guide for your computer's graphics card. Installation is complete. Enjoy your new VG175 ViewPanel. To be best prepared for any future customer service needs: • Write the serial number (see back of the ViewPanel) in "For Your Records" on page 2. • Register the warranty of your ViewPanel on the Internet at: www.viewsonic.com 2 Connect power cord and AC/DC adapter Connect the power cord and AC/DC adapter from the ViewPanel to a properly grounded AC outlet. 3 Power-ON ViewPanel and computer Power-ON the ViewPanel, then power-ON the computer. This sequence (ViewPanel before computer) is very important. NOTE: At this point Windows® 95, 98, and 2000 users may receive a message asking them to install the ViewSonic VG175 INF file. Power cord with adapter to wall plug Video cable to computer 4 ViewSonic VG175