ViewSonic X1000-4K - Ultra-Short Throw 4K UHD Projector with 2400 LED Lumens USB - Page 15
Remote Control - Receiver Range, Replace only with the same or equivalent type recommended by
View all ViewSonic X1000-4K - Ultra-Short Throw 4K UHD Projector with 2400 LED Lumens USB C Bluetooth Speakers and Wi-Fi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Remote Control - Receiver Range To ensure proper function of the remote control follow the steps below: 1. The remote control must be held at an angle within 30° perpendicular to the projector's IR remote control sensor(s). 2. The distance between the remote control and the sensor(s) should not exceed 8 m (26 ft.) NOTE: Refer to the illustration for the location of the infrared (IR) remote control sensor(s). Approx. 30° Remote Control - Replacing the Batteries 1. Remove the battery cover from the bottom of the remote control by pressing the finger grip and sliding it across. 2. Remove any existing batteries (if necessary) and install two AAA batteries. NOTE: Observe the battery's polarities as indicated. 3. Replace the battery cover by aligning it with the base and pushing it back into position. NOTE: • Avoid leaving the remote control and batteries in excessive heat or a humid environment. • Replace only with the same or equivalent type recommended by the battery manufacturer. • If the batteries are drained or if you will not be using the remote control for an extended period of time, remove the batteries to avoid damage to the remote control. • Dispose of the used batteries according to the manufacturer's instructions and local environment regulations for your region. 15