Viking 24" Outdoor Refrigerated Drawers Installation / Use and Care Instructio - Page 4

INSTALLING YOUR APPLIANCE Select Location The proper location will ensure peak performance of your appliance. We recommend a location where the unit will be out of direct sunlight and away from heat sources. To ensure your product performs to speci¿cations, the recommended installation location temperature range is from 5 to 1°F (1 to °C). Front Grille, keep this area open. Cabinet Clearance Ventilation is required from the bottom front of the appliance. Keep this area open and clear of any obstructions. Adjacent cabinets and counter top can be installed around the appliance as long as the front grille remains unobstructed. Front Leveling Legs Figure 2 Rear Leveling Legs ! CAUTION Leveling Legs Adjustable legs at the front and rear corners of the appliance should be set so the unit is ¿rmly positioned on the Àoor and level from side to side and front to back. The overall height of your appliance may be adjusted between the minimum, 333»4" (85.7 cm), by turning the leveling leg in (CW ඟ) and the maximum, 343»4" (88.3 cm) by turning the leveling leg out (CCW ඞ . Front Grille Do not obstruct the front grille. The openings within the front grille allow air to Àow through the condenser heat exchanger. Restrictions to this air Àow will result in increased energy usage and loss of cooling capacity. For this reason it is important this area not be obstructed and the grille openings kept clean. Viking Range,LLC does not recommend the use of a custom made grille as air Àow may be restricted. (See Figure 2). To adjust the leveling legs, place the appliance on a solid surface and protect the Àoor beneath the legs to avoid scratching the Àoor. With the assistance of another person, lean the appliance back to access the front leveling legs. Raise or lower the legs to the required dimension by turning the legs. Repeat this process for the rear by tilting the appliance forward using caution. On a level surface check the appliance for levelness and adjust accordingly. The front grille screws may be loosened and the grille adjusted to the desired height. When adjustment is complete tighten the two front grille screws. (See Figure 5). 4