Viking VCWH 1200 CFM Exterior-Power Ventilator Kit - Installation Instructions - Page 1
Viking VCWH Manual
View all Viking VCWH manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
MODEL DEV1200 EXTERIOR MOUNTED VENTILATOR FOR USE WITH :CWH, VICH, DBCV, DICV, DCWH, DCWL, DCWN, DTWS AND DCIH :-/-2+RANGE00' HOODS. 30" TO 66" WIDE, 9" TO 18" HIGH. READ AND SAVE THESE INSTRUCTIONS WARNING TO REDUCETHE RISK OF FIRE,ELECTRIC SHOCK,OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: 1. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer or your distributor. 2. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. 3. Installation work and electrical wiring must be done by a qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction codes and standards. 4. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufacturer's guideline and safety standards such as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities. WARNING 5. When cutting or drilling into wall, or ceiling, do not damage electrical wiring or other hidden utilities. 6. Ducted fans must always be vented to the outdoors. 7. To reduce risk of fire, use only metal ductwork. 8. This unit must be grounded. CAUTION 1. For general ventilating use only. Do not use to exhaust hazardous or explosive material and vapors. 2. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit. 3. Please read specification label on product for further information and requirements. 4. Electrical circuit, including speed control, (if used), must be rated 6 amps minimum. Blower Dimensions 22 x 30.828 x 12.724 SPECIFICATIONS MODEL VOLTS AMPS DEV1200 120 3.0 CFM 1200 DUCT SIZE 10" DIA. PLAn THE INSTALLATION ALL INSTALLATIONS MODEL DEV1200 EXTERIOR VENTILATOR 10" ROUND DUCT 10" ROUND ELBOW 10" ROUND DUCT 1. Locate the ventilator so the length of the duct run and number of elbows needed are kept to a minimum. 2. Where possible, ventilator should be centered between wall studs or roof rafters. 3. Avoid pipes, wires, or other ductwork that may be running through the wall. SOFFIT WALL HOOD CANOPY (island canopy available) SOFFIT WALL HOOD CANOPY (island canopy available) MODEL DEV1200 EXTERIOR VENTILATOR TYPICAL ROOF MOUNTED INSTALLATION TYPICAL WALL MOUNTED INSTALLATION INSTALLER: Leave This Manual With The Homeowner HOMEOWNER: Use And Care Information On Page 4