Vivitar IPC-112 User Manual - Page 30

Connection Failed: You have switched the Wi-Fi connection on your camera. Snapshot taken during video recording on an iPhone 6 is not saved to iPhone. connected the camera to initially). 3. Launch the Capture Cam2 app on your phone. Your phone may reconnect automatically. If it did not, you will need to tap on the menu button by your camera name in the main screen and then tap on "re-connect" (you may need to tap "re-connect" a couple of times but eventually) your phone will connect to your camera with a different Wi-Fi network. Note: App can perform slower while the phone and the camera are connected to different Wi-Fi networks. 1. Exit the Capture Cam2 app on your phone. 2. Go to Wi-Fi settings on your phone and select the Wi-Fi network you wish to connect to. 3. Use the RESET tool to push and hold the 'Reset' button found on the back of the camera for 10 seconds. 4. Wait 1 minute until the blue light is blinking rapidly above the camera lens. 5. Open the app and select "Add Camera" and then tap on "New camera setup" 6. Enter the correct Wi-Fi credentials and tap the "Done" button. Your camera should now be connected. Note: If you saved the camera you were previously connected to in the main screen it will automatically connect to that camera. If you have manually removed the old camera from the app then you will be prompted to enter the desired camera name and location and only then it will connect. Create an album manually on your iPhone named Capture Cam2. The snapshots will be saved to that album. 29