Vtech CL80100 User Manual - Page 10

Vtech CL80100 Manual

Get Vtech CL80100 PDF manuals and user guides View all Vtech CL80100 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Getting started Battery installation and charging Install the battery as shown on page

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
6
Battery installation and charging
Install the battery as shown on page 7.
Once you have installed
the battery, the screen indicates the battery status (see table
below). If necessary, place the handset in the telephone base or
charger to charge the battery. For best performance, keep the
handset in the telephone base or charger when not in use. The
battery is fully charged after 16 hours of continuous charging.
See
the table on page 31 for battery operating times.
If the screen shows
Place in charger
and
flashes, you need to
charge the handset without interruption fo
r at least 30 minutes to
give the handset enough charge to use the telephone for a short
time.
The following table summarizes the battery charge indicators
and actions to take.
Getting started
Battery indicators
Battery status
Action
The screen is blank
or shows
Place in
charger
and
(flashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without interruption until
the screen shows
Low battery
or
HANDSET X
(at least 30
minutes).
The screen shows
Low battery
and
(flashing).
Battery has enough
charge to be used for a
short time.
Charge without interruption until
the screen shows
HANDSET X
(at
least 30 minutes).
The screen shows
HANDSET X
.
Battery is charged.
To keep the battery charged,
place it in the telephone base or
charger when not in use.
NOTE:
If you are on a phone call in low battery mode, you hear four short
beeps every minute.