Vtech CL80100 User Manual - Page 13

Adding the handset to your telephone base Adding and registering handsets The handset needs to register with the telephone base before use. You must register each handset separately. When first purchased, all expansion handsets alternately show 1.Press HS LOC on base 4sec and 2.Then press # on handset on the screen. The new handset should be charged without interruption for at least 30 minutes before registering it to the telephone base. 1.Press HS LOC on base 4sec 2.Then press # on handset To register a handset to your telephone base (for AT&T CL81100/CL81200/CL81300/CL82100/CL82200/ CL82250/CL82300/CL82350/CL82400/CL82450/CL82500/ CL82550/CL82600 model) 1. Make sure the handset is out of the telephone base or charger and alternately shows 1.Press HS LOC on base 4sec and 2.Then press # on handset before you begin registration. Registering...Please wait 2. Press and hold /HANDSET LOCATOR on the telephone base for about four seconds, until the red IN USE light on the telephone base is on. Release the button. HANDSET X 3. Press # (pound key) on the handset. The screen Registered shows Registering...Please wait. It takes up to 60 seconds to complete registration. Then HANDSET X Registered appears on the screen, with X being the handset number (1-12), and the handset beeps. The handset is now registered with the telephone base. If registration is not successful, Registration failed appears on the screen. Start again from step one above.