Vtech Three Handset Cordless Answering System including a Cordless DECT 6.0 Head - Page 2

Headset charger installation Install the headset charger as shown below. Plug the small end of the headset charger power adapter into the power jack of the headset charger. Plug the large end of the headset charger power adapter into an electrical outlet not controlled by a wall switch. Headset charger Power on the headset Power on the headset before use. Place the headset in the headset charger or press and hold for two seconds. The light flashes three times in blue and you hear three beeps when the headset is being powered on. Headset charging Charge the headset as shown below. If the light does not turn on while charging, you need to charge the headset without interruption for at least 15 minutes to give the headset enough charge to use for a short time. For best performance, charge the headset continuously for at least three hours. 1. Place the tip of the headset in the small cradle on the headset charger. 2. The magnet holds the top of the headset in place. The light turns on when charging. Telephone base overview IN USE light Flashes when there is an incoming call, or another telephone sharing the same line is in use. On when the telephone is in use, or the answering system is answering a call. X/DELETE Delete the message currently playing. Press twice to delete all old messages when the telephone is not in use. Message window Shows the number of messages and other answering system information. /VOL and VOL/ Adjust the volume during playback. Adjust the telephone base ringer volume when the telephone is not in use. /FIND HANDSET Page all system handsets and headset. /REPEAT Repeat a message or press twice to play the previous message. /ANS ON/OFF Turn the answering system on or off. /SKIP Skip to the next message. /PLAY/STOP Play messages. Stop message playback.