Vtech VH621 User Manual - Page 22

Adding and registering a new headset - vh6211

Get Vtech VH621 PDF manuals and user guides View all Vtech VH621 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

Appendix Adding and registering a new headset Option 1: Register a headset to your VH6210/VH6211 headset base 1. Make sure the battery is properly installed in the headset. The LED light flashes slowly in red and blue to indicate the headset is not registered. 2. Place the headset in the headset base and allow it to charge for at least one hour before beginning registration. 3. Remove the headset from the headset base. 4. Press and hold the PAIR button for about four seconds until the PHONE light on the headset base turns on, and then release the button. 5. Return the headset to the headset base for registration. The LED light alternates quickly in red and blue. It takes about 60 seconds to complete the registration process. Once the headset is registered, The LED light turns red when the battery is low and being charged, or turns purple when the battery is well charged, or turns blue when the battery is fully charged. If the registration fails, you hear the voice prompt "Not registered" when you press the ON/OFF button on the headset, and the ON/ OFF button light on the headset alternates slowly in red and blue. Try the registration process again. NOTE: • You cannot register a headset if another system headset is in use. 18

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
18
Appendix
Adding and registering a new headset
Option 1: Register a headset to your VH6210/VH6211 headset base
1. Make sure the battery is properly installed in
the headset. The
LED
light flashes slowly in
red and blue to indicate the headset is not
registered.
2. Place the headset in the headset base and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the headset base.
4. Press and hold the
PAIR
button for about four
seconds until the
PHONE
light on the headset
base turns on, and then release the button.
5. Return the headset to the headset base for
registration. The
LED
light
alternates quickly in
red and blue.
It takes about 60 seconds to complete the
registration process. Once the headset is registered,
The
LED
light turns red when the battery is low
and being charged, or turns purple when the
battery is well charged, or turns blue when the
battery is fully charged.
If the registration fails, you hear the voice prompt
"Not registered"
when you press
the
ON/OFF
button on the headset, and the
ON/
OFF
button light on the headset alternates slowly in red and blue. Try
the registration process again.
NOTE:
•
You cannot register a headset if another system headset is in use.