Weber Genesis 1000 LX NG Owner Manual

Weber Genesis 1000 LX NG Manual

Get Weber Genesis 1000 LX NG PDF manuals and user guides View all Weber Genesis 1000 LX NG manuals
Add to My Manuals
Save this manual to your list of manuals

Weber Genesis 1000 LX NG manual content summary:

  • Weber Genesis 1000 LX NG | Owner Manual - Page 1
    with the factory. GENESIS® 1000 LX Natural Gas Barbecue Owner's Manual WEBER WEBER ® WARNING: Follow all leak check procedures carefully in this manual prior to barbecue operation. Do this even if barbecue was dealer assembled. NOTICE TO INSTALLER: These instructions must be left with
  • Weber Genesis 1000 LX NG | Owner Manual - Page 2
    assembly may be dangerous. Please carefully follow the assembly instructions in this manual. ƽ After a period of storage, and/or nonuse, the Weber Gas Barbecue should be checked for gas leaks and away from LP tank. 2. Do not attempt to correct the problem yourself. 3. Call your fire department. 2
  • Weber Genesis 1000 LX NG | Owner Manual - Page 3
    and operated in accordance with the printed instructions accompanying it. Weber may require reasonable proof of your date service, or failure to perform normal and routine maintenance, including but not limited to damage caused by insects within the burner tubes, as set out in this owner's manual
  • Weber Genesis 1000 LX NG | Owner Manual - Page 4
    ; Perma-Mount, Gas Catcher, FlameCheck, Steam-N-Chips, Spider Stopper, and Warm-Up are U.S. trademarks of Weber-Stephen Products Co., 200 East Daniels Road, Palatine, IL 60067-6266. U.S.A. Genesis Gas Barbecues are covered under the following patent nos.: U.S.A. #4,677,964; 4,727,853; #4,777,927
  • Weber Genesis 1000 LX NG | Owner Manual - Page 5
    Instructions 6 Assembly 7-21 Operating Instructions Lighting 22-23 Cooking 24 Storage and/or Nonuse 24 Cleaning 24 Troubleshooting & Maintenance Annual Maintenance 25 General Maintenance 26-28 Troubleshooting past to help prevent flare-ups. e) Weber Warm-Up Basket for additional cooking or
  • Weber Genesis 1000 LX NG | Owner Manual - Page 6
    instructions will give you the minimum requirements for assembling your Weber Gas Barbecue. Please read the instructions carefully before using your Weber from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system
  • Weber Genesis 1000 LX NG | Owner Manual - Page 7
    error may occur. If a part is missing, do not go back to the store. Call the Weber Customer Service Center toll free 1-800-446-1071 to receive immediate assistance. Have your owner's manual and serial number of the barbecue available for reference. Bottom tray Two cooking grates Control panel 7
  • Weber Genesis 1000 LX NG | Owner Manual - Page 8
    accessory trays Warming rack Warm-Up Basket Five long Flavorizer Bars Eight short Flavorizer Bars Front panel Catch pan holder Catch pan Two drip pans Manifold bracket Thermometer ER Two wheels Two casters Spacer bracket 8 WE B ER WE B
  • Weber Genesis 1000 LX NG | Owner Manual - Page 9
    Check contents of hardware packs Three burner control knobs Three tool holders Five tubing plugs (two are spares) Swing table end bracket Two hinge pins (hardware size: 1/4 x 1 1/2 inch clevis pin) (actual size) Five 1/4-20 x 2 inch bolts (actual size) Six 1/4-
  • Weber Genesis 1000 LX NG | Owner Manual - Page 10
    the block of wood (or other protected surface). Tap on one hubcap. Put one wheel on the axle, WEBER side toward the hubcap. Slide the axle through the frame. Add the other wheel, WEBER side out. Tap on the hubcap. Figure 1. ER WE B ER WE B Step 3 Assemble frame You will need: left
  • Weber Genesis 1000 LX NG | Owner Manual - Page 11
    Step 4 Continue frame assembly You will need: caster frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame
  • Weber Genesis 1000 LX NG | Owner Manual - Page 12
    Step 6 Insert casters You will need: frame assembly and two casters. Push the casters firmly into the inserts in the ends of the caster legs. Figure 5. Step 7 Add front panel You will need: front panel and two plastic buttons. Turn frame assembly right side up. Align the panel with the holes in the
  • Weber Genesis 1000 LX NG | Owner Manual - Page 13
    in the frame so the burner tubes are under the frame brace. Figure 7. Burner tubes Frame brace Your Weber Gas Barbecue burner assembly has you answered NO, the burners are misaligned. Contact Weber-Stephen Customer Service. Do not use barbecue. Guide screw Figure 7 Slide the cooking box to the
  • Weber Genesis 1000 LX NG | Owner Manual - Page 14
    , bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Figure 10. Frame brace Manifold bracket Step 10 Install igniter Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to
  • Weber Genesis 1000 LX NG | Owner Manual - Page 15
    2526 psi). s A manual shut-off valve must be installed outdoors, immediately ahead of the quick disconnect. s An additional manual shut-off valve indoors 0.3 grams of hydrogen sulfide per 100 cubic feet of gas. s Plastic tubing is suitable only for outdoor, underground use. s Gas piping in contact
  • Weber Genesis 1000 LX NG | Owner Manual - Page 16
    down and turning clockwise. If they do not turn they are off, proceed to the next step.Figure 13. Step 13 Connect flexible hose to manifold You will need: the 12 foot natural gas supply hose and a 3/4 inch wrench. Thread fitting end of hose onto
  • Weber Genesis 1000 LX NG | Owner Manual - Page 17
    solution. If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact Weber-Stephen Customer Service. b) Valves to manifold connections. Figure 16 (b). c) Hose to quick disconnect connection. Figure 16 (c). ƽWARNING: If there is a leak at connections
  • Weber Genesis 1000 LX NG | Owner Manual - Page 18
    Step 15 Install Flavorizer Bars and Cooking Grates You will need: five long Flavorizer Bars, eight short Flavorizer Bars and two cooking grates. Set the long Flavorizer Bars side to side in the lower position, then set the short Flavorizer Bars front to back in the upper position in the cooking box.
  • Weber Genesis 1000 LX NG | Owner Manual - Page 19
    Step 17 Install Lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 22. Hair pin cotter Hinge pin Step 18 Add
  • Weber Genesis 1000 LX NG | Owner Manual - Page 20
    the end bracket at an angle so the lower tab is inside the frame tube. Push the bracket into the frame. Check to see that the lower table. Call our Customer Service Center to order a new part. ƽWARNING: The load limit for the swing table is 30 pounds. Hinge rod (a) (b) Support rod (a) Figure 24
  • Weber Genesis 1000 LX NG | Owner Manual - Page 21
    rack, work table, accessory rack, three tubing plugs, thermometer and a hammer. Insert one end of the Weber Warm-Up Basket into the hole in them lightly with a hammer. Figure 28 (f). Figure 26 To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table
  • Weber Genesis 1000 LX NG | Owner Manual - Page 22
    Lighting Summary lighting instructions are on the control panel. ƽ DANGER Failure to any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Order from Weber-Stephen Products Co., Customer Service Center or authorized dealer. Crossover Ignition System 1 1) Open the
  • Weber Genesis 1000 LX NG | Owner Manual - Page 23
    and turn clockwise.) 3) Turn gas supply valve on. 4) Strike a match and put the flame into the matchlight hole in the front of the cooking box. Manual Lighting 1 ƽWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the
  • Weber Genesis 1000 LX NG | Owner Manual - Page 24
    medium). See your Weber cookbook for detailed cooking instructions. Note: The temperatures minutes before relighting. Preheating Your Weber Genesis Gas Barbecue is an energy the Weber-Stephen Customer Service Center. - Brush any debris off of burners tubes. DO NOT ENLARGE BURNER PORTS (OPENINGS
  • Weber Genesis 1000 LX NG | Owner Manual - Page 25
    Weber-Stephen Products Co., Customer Service Center or authorized dealer. s Inspect the burners for correct flame pattern. Clean if necessary, following the procedures outlined in the "General Maintenance" section of this manual Contact Weber-Stephen Customer Service. b) Valves to manifold
  • Weber Genesis 1000 LX NG | Owner Manual - Page 26
    the burner tube, follow the burner cleaning procedures. Main Burner Cleaning Procedure Turn off the gas supply. Remove the manifold. (See Section Do not enlarge the burner ports when cleaning. Replacing Main Burners a) Your Weber Gas Barbecue must be OFF and cool. b) Turn gas OFF at source. c)
  • Weber Genesis 1000 LX NG | Owner Manual - Page 27
    two wing nuts that hold the manifold to the cooking box. Pull the manifold and valve assembly out of the burners and carefully set it down. Figure 10. View from behind cooking box Burner (b) Wing nuts Figure 10 f) Slide the burner assembly out from under the guide screw and washer in the corners
  • Weber Genesis 1000 LX NG | Owner Manual - Page 28
    ƽCAUTION: If the Spider Stopper Guards do not fit tightly, contact Weber-Stephen Customer Service. ƽWARNING: After reinstalling the gas lines, they should be leak If the Crossover Ignition System still fails to light, See Section "Manual Lighting", and contact Weber-Stephen Customer Service. 28
  • Weber Genesis 1000 LX NG | Owner Manual - Page 29
    TROUBLESHOOTING Problem Burners burn with a yellow or orange flame, in conjunction with the smell of gas. Check Inspect Weber Spider Stopper Guards for possible obstructions. (Blockage of holes.) Cure Clean Weber run the whole length of the burner tube. Clean burners. (See Section "General
  • Weber Genesis 1000 LX NG | Owner Manual - Page 30
    1 2 3 4 5 6 7 8 9 10 11 12 13 14-15 16 17 10,14 18 19-20, 10 21 22 23 24 25 ® ® E BE R W E BE R W 32 26 27 28 29 30 31 33 34 30 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 58 52-55 56 57
  • Weber Genesis 1000 LX NG | Owner Manual - Page 31
    your owner's manual and serial number of the barbecue available for reference. Weber-Stephen Products Company Customer Service Center 250 South tube 45 Front and back burners (2) 46 Center burner 47 1/4-20 stainless steel wing nuts (2) 48 Spider Stopper Guards (3) 49 Manifold assembly 50 Manifold
  • Weber Genesis 1000 LX NG | Owner Manual - Page 32
    problems with parts or assembly. Call our toll free number 1-800-446-1071. For quicker service, please have your owner's manual available for reference. We also welcome any comments or suggestions you might have regarding our products. We wish your family the best in outdoor cooking enjoyment. Weber
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
W
E
B
E
R
W
E
B
E
R
GENESIS
®
1000 LX
Natural Gas Barbecue
Serial Number
Please use this number in registering your warranty and
any correspondence with the factory.
Owner’s Manual
98645
12/97
®
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
NOTICE TO INSTALLER: These instructions
must be left with the owner and the owner
should keep them for future use.
WARNING: Follow all leak check procedures
carefully in this manual prior to barbecue
operation. Do this even if barbecue was
dealer assembled.
WARNING: Do not try to light this appliance
without reading "Lighting" instructions
section of this manual.
THIS GAS APPLIANCE IS DESIGNED FOR
OUTDOOR USE ONLY.
FOR YOUR SAFETY
If you smell gas:
1.
Shut off gas to the appliance.
2.
Extinguish any open flame.
3.
Open lid.
4.
If odor continues, immediately call your
gas supplier or your fire department.