Weber Genesis 1000 LX NG Owner Manual - Page 19

Step 17 Install Lid You will need: lid, two hinge pins and two hair pin cotters. Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 22. Hair pin cotter Hinge pin Step 18 Add tool holders, control panel and burner control knobs You will need: three tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs. Hook the tool holders over the frame rail. Figure 23. Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 23 (a). Push on the burner control knobs. Figure 23 (b). Insert in frame brace (a) Crossover Ignition Button Figure 22 Control panel Phillips screws/ washers (b) Tool holders Figure 23 19