Weber Genesis 1000 LX NG Owner Manual - Page 11
Step 4, Step 5
View all Weber Genesis 1000 LX NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Step 4 Continue frame assembly You will need: caster frame, wheel frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench. Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. Figure 3. The leg tabs must be on the inside of the frames. Add the washers to the bolts, insert in the holes as shown and tighten with the wrench. Figure 3. Dimples to the inside Step 5 Complete frame assembly You will need: partial frame assembly, two frame connectors, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench. Hold one frame connector between the caster and wheel frame. Add the nylon washer to the bolt. Put the bolt through the frame and screw into frame connector. Tighten. Repeat procedure with the other frame connector. Figure 4. Figure 3 Figure 4 11