Weber Genesis Silver B NG Owner Manual - Page 14
Continue frame assembly, do not tighten bolts on wheel, frame until a later step., Complete frame
View all Weber Genesis Silver B NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Continue frame assembly You will need: caster frame, wheel frame, four 1/2 inch bolts, four nylon washers and a 7/16 inch or adjustable wrench. Place the caster frame onto the tabs of the left frame, so that the swing table locking latch(1) is to the rear. Place the wheel frame onto the tabs of the right frame. The leg tabs must be on the inside of the frames. Add the washers to the bolts. Insert the bolts into the holes as shown, do not tighten bolts on wheel frame until a later step. (1) Complete frame assembly You will need: partial frame assembly, two frame connectors, four 2 inch bolts, four nylon washers and a 7/16 inch or adjustable wrench. Hold one frame connector between the caster frame and wheel frame. Add the nylon washer to the bolt. Insert the bolt through the frame and screw into frame connector. Tighten bolt with wrench. Repeat procedure with the other frame connector. B-2