Weber Genesis Silver B NG Owner Manual - Page 24
Do not use the work surface as a cutting board., Install the work surface
View all Weber Genesis Silver B NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4.) While holding swing-up work surface in position, insert the other end of the swing-up work surface rod into the left end trim piece. Push the trim piece into the frame. To raise swing-up work surface: Lift table all the way up and slide it to the right, then lower table until you feel it lock in the up position. To lower swing-up work surface: Lift table up until it disengages and slide it to the left. Then lower it all the way down so that the locking pin on the right side of the table fits into the locking braket on the leg, which will secure the table in the down position. Do not use the work surface as a cutting board. 5.) Add a washer to each bolt and insert it through the hole in the frame and the hole in the trim piece on both sides. Tighten with a wrench. Install the work surface You will need: work surface. Place the work surface, so that the front and back edges fit over the frame, in the area between the left trim piece and the cooking box as shown. Do not use the work surface as a cutting board. (1) (1) Make sure that the tabs on the side table are to the right, next to the cooking box. C-2