Weber Genesis Silver C NG Owner Manual - Page 20

Install the work surface You will need: work surface. Place the work surface, so that the front and back edges fit over the frame, in the area between the left trim piece and the cooking box as shown. Do not use the work surface as a cutting board. Set the side burner in place in the frame. The side burner locking clip on the right should latch under the right trim piece. (1) (1) Make sure that the tabs on the side table are to the right, next to the cooking box. Install side burner You will need: side burner, ƽ WARNING: Make sure gas supply is off. Start the side burner hose into the opening between the control panel and right trim piece route the hose between the cylinder panel and wheel frame. Tilt the side burner slightly, toward the control panel. Latch the side burner locking clip on the left, under the control panel. Push side burner control knob onto the valve C-3