Weber Genesis Silver C NG Owner Manual - Page 33
Side Burner Troubleshooting, Side Burner maintenance
View all Weber Genesis Silver C NG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Side Burner Troubleshooting ƽ WARNING: Before attempting any troubleshooting steps, all gas controls and supply valves should be in the OFF position. Problem Side Burner does not light. Check Is gas supply off? Cure Turn supply on. Flame is low in HIGH position. Is the fuel hose bent or kinked? Straighten hose. Flame is very yellow in conjunction with the smell of gas, OR Inspect the Spider/Insect Screens for possible obstructions. (lockage of holes.) Burner makes popping noise in conjunction with the smell of gas. Push button ignition does not work. Does burner light with a match? Clean Spider/Insect Screens. (See section "Annual Maintenance") If match lights burner, checkigniter (see below). Side Burner maintenance ƽ WARNING: All gas controls and supply valves should be in the OFF position. Check igniter: Remove side burner cover. To remove side burner cover, remove control knob and screws that hold cover to bottom(1). Make sure wire is connected between igniter and electrode. Check that igniter lock nut is tight. Note: If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers. Adjust igniter electrode to burner. Gap should be 1/8 to 3/16 inch from tip of electrode to burner. Spark should be a white/blue color, not yellow. 1) Igniter 2) Igniter Wire 3) Venturi/Burner 4) 1/8 to 3/16 inch gap between electrode and burner (4) (1) (2) (3) D-10