Weber Q 120 Owner Manual - Page 4

Gas Instructions - propane gas grill

Page 4 highlights

 GAS INSTRUCTIONS Attach Propane Cylinder Use propane cylinders with a capacity of 14.1 oz or less. Use propane cylinders that are approximately 3" inches in diameter and 11" inches in length. The propane cylinder must fit through the cylinder support ring (1). You can find this tank in the camping, hardware, plumbing section of the store you are shoppping at. m CAUTION: Use cylinders that are marked "Propane fuel" only. Note: Your Weber® gas grill is equipped with a cylinder supply system designed for vapor withdrawal. Slide propane cylinder through support ring (1). While holding carrying handle closest to propane cylinder with one hand, push propane cylinder into regulator and turn clockwise until tight. m WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak. Check for gas leaks: 1) Regulator to propane cylinder connection. m WARNING: If there is a leak at connection (1), remove propane cylinder. Do not operate grill. Use a different propane cylinder and recheck for leaks with soap and water solution. If a leak persists after retightening the propane cylinder, turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. 2) Valve to-regulator connections. m WARNING: If there is a leak at connection (2) turn OFF the gas. DO NOT OPERATE THE GRILL. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water. m DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion which can cause serious bodily injury or death, and damage to property. m DANGER Do not store a spare LP-gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full. If the instructions are not followed exactly, a fire causing death or serious injury may occur. Check for gas leaks After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety. • Inspect the burner for correct flame pattern. Clean if necessary, following the procedures outlined in the "General Maintenance" section of this manual. • Check all gas fittings for leaks. m WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note: All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber® gas grill. Shipping and handling may have loosened or damaged a gas fitting. m WARNING: Perform these leak checks even if your grill was dealer- or store-assembled. You will need a soap and water solution and a rag or brush to apply it. To perform leak checks make sure the Burner is in the off position and turn on gas supply. m WARNING: Do not ignite burner while leak checking. Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak. Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks. m ATTENTION: This product has been safety tested and is only certified for use in a specific country. Refer to country designation located on outer carton. These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products Co., Customer Service Department for genuine Weber-Stephen Products Co. replacement part(s) information. m WARNING: Do not attempt to make any repair to gas carrying or gas burning components without contacting Weber-Stephen Products Co., Customer Service Department. Your actions, if you fail to follow this product Warning, may cause a fire or an explosion resulting in serious personal injury or death and damage to property.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

4
Attach Propane Cylinder
Use propane cylinders with a capacity of 14.1 oz or less. Use propane cylinders
that are approximately 3” inches in diameter and 11” inches in length. The
propane cylinder must fit through the cylinder support ring (1).
You can find this tank in the camping, hardware, plumbing section of the store
you are shoppping at.
m
CAUTION: Use cylinders that are marked “Propane fuel” only.
Note: Your Weber
®
gas grill is equipped with a cylinder supply system designed
for vapor withdrawal.
Slide propane cylinder through support ring (1). While holding carrying handle
closest to propane cylinder with one hand, push propane cylinder into regulator
and turn clockwise until tight.
m
WARNING: Do not use a wrench to tighten the connection.
Using a wrench could damage the regulator coupling and
could cause a leak.
Check for gas leaks:
1)
Regulator to propane cylinder connection.
m
WARNING: If there is a leak at connection (1), remove
propane cylinder. Do not operate grill. Use a different
propane cylinder and recheck for leaks with soap and water
solution. If a leak persists after retightening the propane
cylinder, turn OFF the gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.com
®
.
2)
Valve to-regulator connections.
m
WARNING: If there is a leak at connection (2) turn OFF the
gas. DO NOT OPERATE THE GRILL.
Contact the Customer Service Representative in your area using the
contact information on our web site. Log onto www.weber.com
®
.
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water.
m
DANGER
Do not use an open flame to check for gas leaks. Be
sure there are no sparks or open flames in the area
while you check for leaks. Sparks or flames will result
in a fire or explosion which can cause serious bodily
injury or death, and damage to property.
m
DANGER
Do not store a spare LP-gas cylinder under or near this
appliance. Never fill the cylinder beyond 80 percent
full. If the instructions are not followed exactly, a fire
causing death or serious injury may occur.
Check for gas leaks
After a period of nonuse, we recommend that you perform the following
maintenance procedures for your safety.
• Inspect the burner for correct flame pattern. Clean if necessary, following the
procedures outlined in the “General Maintenance” section of this manual.
• Check all gas fittings for leaks.
m
WARNING: You should check for gas leaks every time you
disconnect and reconnect a gas fitting.
Note: All factory-made
connections have been thoroughly checked for gas leaks. The burners have
been flame tested. As a safety precaution however, you should recheck all
fittings for leaks before using your Weber
®
gas grill. Shipping and handling
may have loosened or damaged a gas fitting.
m
WARNING: Perform these leak checks even if your grill was
dealer- or store-assembled.
You will need a soap and water solution and a rag or brush to apply it. To
perform leak checks make sure the Burner is in the off position and turn on gas
supply.
m
WARNING: Do not ignite burner while leak checking.
Check for leaks by wetting the connections with the soap and water solution
and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
Note: Since some leak test solutions, including soap and water, may be slightly
corrosive, all connections should be rinsed with water after checking for leaks.
GAS INSTRUCTIONS
m
ATTENTION: This product has been safety tested
and is only certified for use in a specific country. Refer
to country designation located on outer carton.
These parts may be gas carrying or gas burning components.
Please contact Weber-Stephen Products Co., Customer Service
Department for genuine Weber-Stephen Products Co. replacement
part(s) information.
m
WARNING: Do not attempt to make any repair to
gas carrying or gas burning components without
contacting Weber-Stephen Products Co., Customer
Service Department. Your actions, if you fail to follow
this product Warning, may cause a fire or an explosion
resulting in serious personal injury or death and
damage to property.