Weber Summit 675 NG Owner Manual - Page 6

LIGHTING EACH HEAT ZONE OPERATES INDEPENDENTLY. Summary lighting instructions are on the control panel. High Medium Low Off ƽ DANGER Failure to open lid while igniting the barbecue, or not waiting 5 minutes to allow the gas to clear if the barbecue does not light, may result in an explosive flameup which can cause serious bodily injury or death. Crossover Ignition System Note - The Crossover Ignition System ignites the Left burner of each heat zone with a spark from the igniter electrode inside the Gas Catcher Ignition Chamber. You generate the energy for the spark by pushing the Crossover Ignition Button until it clicks. ƽWARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Contact your dealer. ƽWARNING: The storage space under the cooking module is intended for storage of nonflammable items only. 1) Open the lid. Figure 1. 2) Make sure all burner control knobs are OFF. (Push each burner control knob down and turn clockwise.) 3) Turn on gas supply. ƽWARNING: Do not lean over open barbecue. Keep your face and body at least one foot away from the matchlight hole when lighting the barbecue. 4) Select Heat Zone. 5) Push LEFT burner control knob down and turn to START/HI. 6) Push the Crossover Ignition Button several times, so it clicks each time. 7) Check that the burner is lit by looking through the matchlight hole above the burner control knob. ƽWARNING: If the burner does not light, turn the LEFT burner control knob to OFF and wait 5 minutes to let the gas clear before you try again or try to light with a match. 8) After the LEFT burner is lit you can turn on the RIGHT burner. Note - Always light the LEFT burner first. The RIGHT burner ignites from the LEFT burner. TO EXTINGUISH Turn gas supply OFF at the source, then push down and turn each burner control knob clockwise to OFF. 6