Weider 8525 English Manual - Page 12

22. Press a 1 1/2" Square Inner Cap (32) into the Seat Frame (36). Insert the 1/4" x 2" Carriage Bolt (38) into the center hole in the Seat Plate (37). Attach the Seat Plate to the Seat (13) with two 1/4" x 3/4" Screws (18). Insert the 1/4" x 2" Carriage Bolt (38) into the indicated hole in the Seat Frame (36). Tighten a 1/4" Nylon Locknut (2) with a 1/4" Washer (10) onto the Carriage Bolt. Attach the other end of the Seat (13) to the Seat Frame (36) with a 1/4" Washer (10) and the 1/4" x 2" Screw (24). 23. Press a 1 1/2" Square Inner Cap (32) into the Leg Lever (29). Lubricate the 5/16" x 2 3/4" Bolt (11). Attach the Leg Lever (29) to the Seat Frame (36) with the Bolt and a 5/16" Nylon Locknut (3). Do not overtighten the Nylon Locknut; the Leg Lever must be able to pivot freely. Insert two 3/8" x 2" Eyebolts (35) into the Leg Lever (29) from the directions shown. Tighten a 3/8" Nylon Locknut (73) and a 3/8" Washer (9) onto each Eyebolt. 24. Press two 3/4" Round Inner Cap (34) into the ends of a 12 1/2" Pad Tube (28). Insert the Pad Tube into the Seat Frame (36). Slide two 5 1/2" Pads (30) onto the Pad Tube. Assemble the other Pad Tube (28) to the Leg Lever (29) in the same manner. 25. Rest the Seat Frame (36) on the indicated pin in the Front Upright (42). Attach the Seat Frame to the Front Upright with a 5/16" x 2 3/4" Carriage Bolt (14) and the Seat Knob (40). 22 38 37 18 32 13 36 10 24 2 23 Lubricate 11 29 9 73 35 3 36 35 73 9 32 24 34 30 29 36 28 28 30 34 25 40 36 14 42 Pin 12