Weider Club 500 Bench English Manual - Page 11

17. Press a 51mm x 76mm Inner Cap (21) into the 17 top of a Front Upright (44). Attach an Upright Cover (51) to the Front Upright with five M4 x 16mm Screws (63). Attach the Front Upright (44) to a Base (42) with four M10 x 94mm Bolts (18), two Small Joint Plates (40), and four M10 Nylon Locknuts (32). Do not tighten the Locknuts yet. Repeat this step with the other Front Upright (44) and the other Base (42). 51 63 63 63 21 44 18. Attach the Left Rear Upright (46) to the left Front Upright (44) with four M10 x 94mm Bolts (18), two Small Joint Plates (40), and four M10 Nylon Locknuts (32). Do not tighten the Locknuts yet. Repeat this step with the Right Rear Upright (not shown). 63 63 40 32 32 18 32 40 18 42 18 40 46 40 44 18 19. Press two 48mm Round Inner Caps (23) into the 19 ends of the two Carriage Tubes (69). Screw the Carriage Tubes onto the Weight Carriage (50) as shown. Make sure the Carriage Tubes are fully tightened. 23 69 50 69 23 11