Weider Club 500 Bench English Manual - Page 6

3. Attach two Bumpers (90) to the Front Stabilizer (3) with two M4 x 13mm Screws (91). Press two Bushings (34) into the Bench Frame (2). Attach the Bench Frame (2) to the Front Leg (4) with four M10 x 94mm Bolts (18), two Joint Plates (39), and four M10 Nylon Locknuts (32). Do not tighten the Locknuts yet. 3 32 39 2 34 34 4 39 18 90 82 82 3 90 4. Press four 20mm x 40mm Inner Caps (20) into 4 the ends of the two Backrest Frames (6). 73 73 20 Attach the Backrest Frames (6) to the Backrest Bracket (9) with four M10 x 58mm Bolts (73), four M10 Washers (74), and four M10 Nylon Locknuts (32). Make sure the Backrest Frames are oriented as shown. The Backrest Frames must be parallel, with the indicated holes aligned. Holes 74 74 6 20 5. Attach the Backrest (10) to the Backrest Frames 5 (6) with four M6 x 53mm Bolts (29) and four M6 Washers (37). Note: If the four Bolts cannot be inserted into the Backrest properly, go back to step 4 and readjust the Backrest Frames. 9 32 10 6 37 37 29 29 6