Weslo 600 Instruction Manual - Page 3
Important Precautions, Warning
View all Weslo 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
REMOVING AND ATTACHING THE LAT TOWER To remove the Lat Tower (40), first remove the Knob (29) from the Frame (51). Next, remove the indicated 5/16" x 2" Bolt (10), 5/16" Washers (3), and 5/16" Nylon Locknut (1). Lift the Lat Tower out of the Frame. To attach the Lat Tower (40), slide the Lat Tower into the Frame (51). Attach the Lat Tower to the Frame with the 5/16" x 2" Bolt (10), the two 5/16" Washers (3), and the 5/16" Nylon Locknut (1). Fully tighten the Knob (29) into the Frame. Note: Make sure that a 1 1/2" Square Inner Cap (not shown) is inserted into the Frame (51) when the Lat Tower (40) is not attached. 40 29 1 3 10 51 USING THE CURL PAD AND CURL TUBE To use the Curl Pad (43), insert the Curl Tube (44) into the Frame (51). Raise the Curl Upright to the desired height, and align one of the holes in the Curl Tube with the hole in the Frame. Insert the Small Locking Pin (38) through the Frame and the Curl Tube. Rotate the Small Locking Pin to the locked position, with the Small Locking Pin clipped onto the Frame. Note: Make sure that a 1 1/2" Square Inner Cap (not shown) is inserted in the Frame (51) when the Curl Pad (43) and Curl Tube (44) are not attached. SECURING THE LEG LEVER When the Leg Lever (45) is not being used, it must be secured with the Large Locking Pin (17). To secure the Leg Lever, hold the Leg Lever against the Frame (51). Slide the Large Locking Pin through the hole in the Leg Lever and secure it behind the Frame as shown. 43 44 51 38 17 51 45 14 IMPORTANT PRECAUTIONS WARNING: To reduce the risk of serious injury, read the following important precau- tions before using the weight bench. 1. Read all instructions in this manual before using the weight bench. 2. It is the responsibility of the owner to ensure that all users of the weight bench are adequately informed of all precautions. 3. The weight bench is intended for home use only. Do not use the weight bench in any commercial, rental, or institutional setting. 125 pounds (57 kg) on the leg lever; do not place more than 30 pounds (14 kg) on the arms. 12. When using the weight carriage, always secure your weights (not included) with the weight clips. 13. Remove the lat bar when performing any exercise that does not require the lat bar. 4. Use the weight bench only on a level surface. Cover the floor beneath the weight bench to protect the floor or carpet. 5. Inspect and tighten all parts regularly. Replace any worn parts immediately. 6. Inspect the cables before each use. Make sure that the cables remain on the pulleys at all times. If a cable binds while you are exercising, stop immediately and make sure that the cable is on the pulleys. Replace both cables every two years. 14. If you feel pain or dizziness while exercising, stop immediately and begin cooling down. 15. The decal shown below has been placed on the weight bench. If the decal is missing or illegible, please call our Customer Service Department at 0345-089009 to order a free replacement decal. Apply the replacement decal in the location shown. 7. The weight bench is designed to be used by only one person at a time. 8. Keep children under 12 and pets away from the weight bench at all times. 9. Always wear athletic shoes for foot protection while exercising. 10. Keep hands and feet away from moving parts. 11. Do not place more than 365 pounds (165 kg) on the weight rests; do not place more than WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product. 3