Weslo Cadence 3350 Treadmill English Manual - Page 10

MAINTENANCE AND TROUBLE-SHOOTING Check all parts periodically to ensure that they are tightened securely. Outside surfaces of the treadmill can be cleaned using a soft cloth and mild, non-abrasive detergent. Do not allow liquids to come in contact with the electronic monitor. WALKING BELT ADJUSTMENT To prevent damage to the walking belt, the belt must be kept centered on the walking platform. If the belt shifts toward the right or left sides of the treadmill, the belt may be damaged by the roller guard screws. The belt can be adjusted with the rear roller adjustment bolts (see the drawings below) and the alien wrench included. The treadmill must be turned on at medium speed when adjusting the belt. CAUTION: Keep your hands away from the moving walking belt or serious injury could result. IF THE WALKING BELT HAS SHIFTED TO THE LEFT: Turn the left adjustment bolt clockwise, and the right adjustment bolt counterclockwise, 1/8 of a turn at a time, until the walking belt is centered. IF THE WALKING BELT HAS SHIFTED TO THE RIGHT: Turn the left adjustment bolt counterclockwise, and the right adjustment bolt clockwise, 1/8 of a turn at a time, until the walking belt is centered. IF THE WALKING BELT SLIPS DURING USE: Turn both adjustment bolts clockwise until the belt no longer slips. Be careful to keep the belt centered. Do not overtighten the bolts. This may cause stretching of the belt, excessive roller noise, and reduced motor performance. To check the walking belt for proper tension, UNPLUG THE POWER CORD, and lift the edges of the walking belt. You should be able to raise each edge 2-3 inches off the walking platform. The center of the belt should remain just at the surface of the platform. The alien wrench can be stored conveniently on the selfadhesive wrench clip included. 1O 2"- 3" O O Wrench Clip