Weslo Momentum L 4.8 Elliptical English Manual - Page 8

7. Identify the Left Handlebar (6), which is marked with a "Left" sticker. 7 Insert the Left Handlebar (6) into a Handlebar Arm (5). Make sure that the hexagonal holes are on the indicated side. Attach the Left Handlebar (6) with two M6 x 38mm Button Bolts (50) and two M6 Locknuts (27). Make sure that the Locknuts are inside the hexagonal holes. Do not tighten the Button Bolts yet. Apply a small amount of the included grease to the left axle on the Upright (2). Slide a Handlebar Spacer (47) and the Left Handlebar (6) onto the left axle on the Upright (2). Make sure that the curved side of the Handlebar Spacer is facing the Upright. Then, tap an Axle Cap (14) onto the axle. Repeat this step for the Right Handlebar (8) and the other Handlebar Arm (5). 6 2 Grease 14 50 5 47 27 Hexagonal Holes 8 5 8. Apply a small amount of grease to the axle on the left Disc Crossbar (16). Slide the Left Pedal 8 Arm (11) onto the axle, and then place a Wave Washer (64) on the axle. Next, tighten an M10 x 25mm Patch Screw (22) and an M10 Washer (35) into the axle. Apply a small amount of grease to a Pedal Arm Bolt Set (40). Next, hold the left Handlebar Arm (5) inside the bracket on the Left Pedal Arm (11). Attach the Left Pedal Arm to the left Handlebar Arm with the Bolt Set. Do not overtighten the Bolt Set; the Handlebar Arm must pivot freely. Attach the Right Pedal Arm (not shown) in the same way. 5 Grease 40 16 Grease See step 5. Tighten the M10 x 68mm Button Bolts (48). See step 7. Tighten the M6 x 38mm Button Bolts (50) in the Handlebar Arms (5). 40 11 64 22 35 9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 8