Weslo Portable Spa Canadian English Manual - Page 14
Diagram Of The Console
View all Weslo Portable Spa manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8. If the level is too low, add half of one of the "QUICK pHix It UP" packets to the water. Let the water circulate through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is correct. If the level is too high, add half of one of the "QUICK pHix It DOWN" packets to the water. Let the water circulate through the spa jet unit for five minutes. Test the pH level again. Repeat until the pH level is correct. Replace the spa cover and allow the water to continue to heat. See WATER CHEMISTRY on page 15 for information concerning proper water maintenance. SECURING THE SPA COVER The spa cover can be secured by snapping the latches on the spa cover into the buckles on the side panels. The buckles can be locked by inserting the key and turning it clockwise a quarter turn. To unlock the buckles, insert the key and turn it counterclockwise a quarter turn. Latch Key Buckle Always keep the buckles locked when the spa is not in use. Keep the keys in a safe place, out of the reach of children. DIAGRAM OF THE CONSOLE USING THE CONSOLE Refer to the console diagram above. The function of each console control is explained below: Primer: This opening allows you to prime the spa jet unit before operation (see PRIMING THE SPA JET UNIT on page 12). Diverter: Controls the flow of water through the hydro-therapy jets and the whirlpool diverter. The direction of the flow can be adjusted by turning the diverter control. When the control is set to "front," the flow will be through the hydro-therapy jets; when it is set to "side," the flow will be through the whirlpool diverter; when it is set to "all," the flow will be evenly distributed through both the hydro-therapy jets and the whirlpool diverter. Thermostat: Controls the temperature of the water. The water heats at about 1.5°F an hour with the cover on. The thermostat can be set to heat the water from 70°F to 104°F. You should use a medical or other accurate thermometer to check the temperature of the water. On/Off: Turns the spa jet unit on and off. To turn the spa jet unit on, press the control once. To turn the spa jet unit off, press the control twice. After you press it once, the spa jet unit will shut off for about 30 seconds, and restart. Press the control again. The spa jet unit will remain off for three hours, at which time it will begin running the filter cycle. At any time after the spa jet unit has been shut off, the pump will begin cycling the water if the temperature falls below the minimum setting. Note: To keep the filter and heat cycles from running, the power cord must be unplugged. Air Control: Determines the amount of air that is in the spa jet system during operation. If the control is turned to the left, the amount of air flowing through the jets will increase. If the control is turned to the right, the amount will decrease. 14