Weslo Pursuit 2.9 Bike Uk Manual - Page 7

4. While another person holds the Upright (2) near the Frame (1), connect the Upper Wire Harness (30) to the Reed Switch Wire (31). Then, connect the Resistance Cable (13) to the Lower Cable (40) in the following way: • See the inset drawing. Insert the end of the Resistance Cable (13) through the connector on the Lower Cable (40) from the side shown. Press the small cylinder on the end of the Resistance Cable into the hole in the connector. • Pull the Resistance Cable (13) upward and insert the Resistance Cable into the hole in the top of the connector. Carefully pull the excess Upper Wire Harness (30) upward from the top of the Upright (2), push the excess Cables (13, 40) downward into the Frame (1), and slide the Upright onto the Frame. Tip: Avoid pinching the wires and cables. Attach the Upright (2) with four M8 x 20mm Button Screws (51), four M8 Split Washers (59), and four M8 Curved Washers (44). 4 30 13 40 31 51 59 44 59 51 13 40 2 44 59 51 Avoid pinching the wires 30 31 1 5. The Console (5) requires two AA batteries; alkaline batteries are recommended. Remove the 5 battery cover from the Console and insert two batteries into the battery compartment. Make sure that the batteries are oriented as shown by the diagram inside the battery compart- ment. Then, reattach the battery cover. Batteries Battery Cover 5 7