Weslo Pursuit 625s Uk Manual - Page 7
Attach the Handlebar 5 to the Handlebar Post 14
 |
View all Weslo Pursuit 625s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. Attach the Handlebar (5) to the Handlebar Post (14) with two M10 x 25mm Button Screws (8) and two M10 Split Washers (31). 3 8 31 5 4. Identify the Left Pedal (28); there is an "L" on the Left Pedal for identification. Using an adjustable wrench, tighten the Left Pedal counterclockwise into the left arm of the Crank (17). Tighten the Right Pedal (not shown) clockwise into the right arm of the Crank (17). 4 28 14 17 5. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat under the exercise cycle to protect the floor. Note: Some hardware may be left over after assembly is completed. 7
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13
-
14
-
15
-
16
 |
 |
7
4
14
31
8
28
17
3
5
3.
Attach the Handlebar (5) to the Handlebar Post (14)
with two M10 x 25mm Button Screws (8) and two
M10 Split Washers (31).
4.
Identify the Left Pedal (28); there is an “L” on the
Left Pedal for identification. Using an adjustable
wrench, tighten the Left Pedal
counterclockwise
into
the left arm of the Crank (17).
Tighten the Right Pedal (not shown)
clockwise
into
the right arm of the Crank (17).
5.
Make sure that all parts are properly tightened before you use the exercise cycle.
Place a mat under
the exercise cycle to protect the floor. Note: Some hardware may be left over after assembly is completed.