Weslo Pursuit Easy 100 Bike Uk Manual - Page 8

4. While another person holds the Handlebar (50) near the Upright (13), insert the Pulse Wires 4 (59) into the Upright and pull them upward out of the top of the Upright. Tip: Do not pinch the wires. Attach the Handlebar (50) to the Upright (13) with the Pivot Clamp (54), the Rear Cover (3), and the Pivot Handle (55). Note: The Pivot Handle (55) functions like a ratchet. Turn the Pivot Handle clockwise, pull it away from the Upright (13), turn it counterclockwise, push it toward the Upright, and then turn it clockwise again. Repeat this process until the Pivot Handle is tight. Attach the Rear Cover (3) to the Upright (13) with an M4 x 15mm Screw (48). 5. The Console (16) requires four AA batteries (not included); alkaline batteries are recommended. 5 IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic compo- nents. Remove the screw, remove the battery cover, and insert the batteries into the battery compartment. Then, reattach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compart- ment. 13 59 54 3 50 55 48 Do not pinch the wires Screw 16 Battery Cover Batteries 8