Whirlpool DU018DWTB Installation Instructions - Page 14

Check operation, If dishwasher does not operate, Complete installation

Page 14 highlights

Complete installation 1. Place the lower panel behind the toekick panel. 2. Place 2-piece toekick against the legs of the dishwasher. 3. Place the inner toekick piece (with slots) against the toekick bracket. The slots should align with toekick bracket screw holes. Allow the bottom edge of the lower toekick to touch the floor. 4. Place larger toekick over the inner piece and install 4 toekick screws. Use additional 2 screws for installations over 33-1/2" (85.09 cm) high. Use both toekick pieces for all installation heights. Use top 4 screw holes Adjust up or down 2-piece toekick Direct wire method: WARNING Electrical Shock Hazard Electrically ground dishwasher. Connect ground wire to green ground connector in terminal box. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Power supply cord method: WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 5. Reconnect power or plug in dishwasher. Check operation 1. Read the Use and Care Guide that came with your dishwasher. 2. Check that all parts have been installed and no steps were skipped. 3. Check that you have all the tools you used. 4. Start dishwasher and allow it to complete the shortest wash cycle. After the first two minutes, unlatch door, wait five seconds, then open door. 5. Check to see that there is water in the bottom of the dishwasher tub. Check that dishwasher is working properly. 6. If not, disconnect power or unplug dishwasher and see "If dishwasher does not operate" section. If dishwasher does not operate First try the solutions suggested here to possibly avoid the cost of a service call. • Has the circuit breaker tripped or the house fuse blown? • Is the door closed tightly and latched? • Has the cycle been set correctly to start the dishwasher? • Is the water turned on? If none of these work, call 1-800-4MY-HOME. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

14
Power supply cord method:
5.
Reconnect power or plug in dishwasher.
Check operation
1.
Read the Use and Care Guide that came with your
dishwasher.
2.
Check that all parts have been installed and no steps
were skipped.
3.
Check that you have all the tools you used.
4.
Start dishwasher and allow it to complete the shortest
wash cycle. After the first two minutes, unlatch door,
wait five seconds, then open door.
5.
Check to see that there is water in the bottom of the
dishwasher tub. Check that dishwasher is working
properly.
6.
If not, disconnect power or unplug dishwasher and see
“If dishwasher does not operate” section.
If dishwasher does not operate
First try the solutions suggested here to possibly avoid the
cost of a service call.
• Has the circuit breaker tripped or the house fuse blown?
• Is the door closed tightly and latched?
• Has the cycle been set correctly to start the dishwasher?
• Is the water turned on?
If none of these work, call 1-800-4MY-HOME.
Complete installation
1.
Place the lower panel behind the toekick panel.
2.
Place 2-piece toekick against the legs of the dishwasher.
3.
Place the inner toekick piece (with slots) against the
toekick bracket. The slots should align with toekick
bracket screw holes. Allow the bottom edge of the
lower toekick to touch the floor.
4.
Place larger toekick over the inner piece and install 4
toekick screws. Use additional 2 screws for installations
over 33-1/2" (85.09 cm) high. Use both toekick pieces
for all installation heights.
Direct wire method:
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
WARNING
Electrical Shock Hazard
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Use top 4
screw holes
Adjust up
or down
2-piece toekick