Whirlpool DU018DWTB Installation Instructions - Page 3

Installation Requirements Tools and Parts Gather the required tools and parts before starting installation. All installations Tools needed: • Phillips screwdriver Parts needed: • Flat - blade screwdriver • 5/16" and 1/4" nut drivers • measuring tape or ruler • 6" adjustable wrench • small level • flashlight • shallow pan • 90° elbow with 3/8" N.P.T. external threads on one end. (The other end must fit your water supply line.) • thread seal tape • 3 UL listed wire nuts • One 1-1/2" - 2" screw type clamp In addition, for new installations Tools needed: • electric drill with 1/2", 3/4" and 1-1/2" hole saw bits • small tubing cutter Parts needed: • copper tubing (3/8" recommended) • clamp connector to fit a 7/8" (22.2cm) diameter hole • One 1-1/2" - 2" screw type clamp if connecting to waste-tee Parts supplied A. 2 - # 8 x 5/8" Phillips flat head wood screws B. 4 - Phillips head, color matched toekick screws Location Requirements Do not run drain lines, water lines or electrical wiring where they can interfere with or contact dishwasher motors or legs. The location where the dishwasher will be installed must provide clearance between motors and flooring. Motors should not touch the floor. Do not install dishwasher over carpeted flooring. Protect dishwasher and water lines leading to dishwasher against freezing. Damage from freezing is not covered by the warranty. Check location where dishwasher will be installed. The location must provide: • easy access to water, electricity and drain. • convenient access for loading and unloading dishes. Corner locations require a 2" (5.1 cm) minimum clearance between the side of the dishwasher door and the wall or cabinet. • there must be a minimum of 25-5/8" (65.1 cm) in front of dishwasher to allow door to open fully. Countertop Dishwasher 25-5/8" ( 65.1 cm) A B Make sure these parts are included. See separate parts list for accessories available for your dishwasher. 2" ( 5.1 cm) clearance for door opening min. • square opening for proper operation and appearance. • cabinet front perpendicular to floor. • level floor. (If floor at front of opening is not level with floor at rear of opening, shims may be needed to level dishwasher.) NOTE: To prevent shifting during dishwasher operation, shims must be securely attached to the floor. If dishwasher will be left unused for a period of time or in a location where it may be subject to freezing, have it winterized by authorized service personnel. Make sure pipes, wires and drain hose are within the shaded area shown in the "Cutout dimensions" section. Helpful Tip: If the floor in the dishwasher opening is uneven (example: tile flooring only partway into opening) you will need to take special care in measuring dimensions and in leveling dishwasher. 3