Whirlpool GY397LXUS Installation Instructions - Page 10

5. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts. 2. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts. A F A E B C E D A. 10-32 hex nut B. Ground-link screw C. Line 1 (black) D. Green ground wire E. Neutral (center) wire F. Line 2 (red) 6. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts. 7. Securely tighten hex nuts. NOTE: For power supply cord replacement, only use a power cord rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening, with ring terminals and marked for use with ranges. 8. Replace terminal block access cover. 3-wire connection: Power Supply Cord Use this method only if local codes permit connecting chassis ground conductor to neutral wire of power supply cord. 1. Feed the power supply cord through the strain relief in the cord/conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block. D B C A. 10-32 hex nut B. Line 1 (black) C. Ground-link screw D. Neutral (white) wire E. Line 2 (red) 3. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts. 4. Securely tighten hex nuts. NOTE: For power supply cord replacement, only use a power cord rated at 250 volts minimum, 40 amps or 50 amps that is marked for use with nominal 1³⁄₈" (3.5 cm) diameter connection opening, with ring terminals and marked for use with ranges. 5. Replace terminal block access cover. Direct Wire Installation: Copper or Aluminum Wire This range may be connected directly to the fuse disconnect or circuit breaker box. Depending on your electrical supply, make the required 3-wire or 4-wire connection. 1. Strip outer covering back 3" (7.6 cm) to expose wires. Strip the insulation back 1" (2.5 cm) from the end of each wire. 1" (2.5 cm) A B C D A. Terminal block B. Ground-link screw C. Cord/conduit plate D. Power supply cord wires 3" (7.6 cm) 2. Allow enough slack in the wire to easily attach the wiring terminal block. 3. Complete electrical connection according to your type of electrical supply (4-wire or 3-wire connection). 4-wire Connection: Direct Wire Use this method for: ■ New branch-circuit installations (1996 NEC) ■ Mobile homes ■ Recreational vehicles ■ In an area where local codes prohibit grounding through the neutral 10