Whirlpool GY397LXUS Installation Instructions - Page 11

1. Part of metal ground strap must be cut out and removed. A B C 4. Attach terminal lugs to line 1 (black), neutral (white), and line 2 (red) wires. Loosen (do not remove) the set screw on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten set screw to torque shown in following Bare Wire Torque Specifications chart. A A. Metal ground strap B. Discard C. Ground-link screw 2. Use Phillips screwdriver to remove the ground-link screw from the back of the range. Save the ground-link screw and the end of the ground-link under the screw. 3. Pull the conduit through the strain relief on cord/conduit plate on bottom of range. Allow enough slack to easily attach wiring to the terminal block. A B C G D FE A. Terminal block B. Ground-link screw C. Cord/conduit plate D. Line 2 (red) wire E. Neutral (white) wire F. Line 1 (black) wire G. Bare (green) ground wire B C D E A. Terminal lug B. Set screw C. Line 1 (black) wire D. Neutral (white) wire E. Line 2 (red) wire Bare Wire Torque Specifications Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m) Wire Awg Torque 8 gauge copper 25 lbs-in. (2.8 N-m) 6 gauge aluminum 35 lbs-in. (4.0 N-m) 5. Use Phillips screwdriver to connect the bare (green) ground wire to the range with the ground-link screw. The ground wire must be attached first and must not contact any other terminal. 6. Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10-32 hex nuts. G A B F DE C A. 10-32 hex nut B. Line 1 (black) C. Bare (green) ground wire D. Ground-link screw E. Neutral (white) wire F. Line 2 (red) G. Terminal lug 7. Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts. 8. Securely tighten hex nuts. 9. Replace terminal block access cover. 11