Whirlpool MED6000XW Installation Instructions - Page 9
Connect remaining wires, Connect neutral wire, Remove center screw, Connect ground wire, Wire Power
View all Whirlpool MED6000XW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
3. Connect ground wire 1. Remove center screw A B F Connect ground wire (F) (green or bare) of power supply cord to external ground conductor screw (A). Tighten screw. 4. Connect remaining wires Remove center, silver-colored terminal block screw (B). 2. Connect neutral wire B C Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. Connect neutral wire (white or center) (C) of power supply cord to center, silver-colored terminal block screw (B). Tighten screw. 3. Connect remaining wires 3-Wire Power Supply Cord Connection Use where local codes permit connecting cabinet-ground conductor to neutral wire. 3-wire receptacle (NEMA type 10-30R) 3-prong plug Spade terminals with upturned ends Ring terminals Connect remaining wires to outer terminal block screws. Tighten screws. Finally, reinsert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. Now, go to Venting Requirements. 9