Whirlpool MH2175XST Use and Care Manual - Page 7

Tones, areaudible, signals, indicating, thefollowing - 0 microwaves

Page 7 highlights

Toneasreaudiblseignalsin, dicatintghefollowing: One tone • Valid entry (short tone) Two tones • End of timer countdown • End of stage in multistage cooking • Control Lock active • Hidden feature has been entered or exited • Reminder, repeat each minute after the end-of-cycle tones Three tones • Invalid entry Four tones • End of cycle To Turn Off/On Valid Entry Tones: With the microwave oven in standby mode, touch and hold the number pad "1" for 3 seconds until 2 tones sound. Touch and hold number pad "1" to turn tones back on. To Turn Off All Tones (except end-of-timer and hidden feature tones): With the microwave oven in standby mode, touch and hold the number pad "2" for 3 seconds until 2 tones sound. Touch and hold number pad "2" to turn tones back on. ,4 Z" The Control Lock shuts down the control panel pads to prevent unintended use of the microwave oven. When the control is locked, only the Vent Fan and Light pads will function. If any other control pad is touched, "LOCKED" will appear in the display and the invalid entry tones will sound. To Lock/Unlock Control: The microwave oven must be in standby mode. Touch and hold CANCEL OFF for 3 seconds until 2 tones sound and a padlock icon appears in the display. Repeat to unlock and remove the padlock icon from display. The vent (exhaust) fan has 3 speeds: high, medium and low. To protect the microwave oven, if the temperature from the range or cooktop below the microwave oven gets too hot, the vent fan will automatically turn on at low speed. It may stay on for up to 1 hour to cool the microwave oven. When this occurs, the vent fan cannot be turned off. If the vent fan pad is touched during automatic fan operation, "AUTO FAN IS ON, FAN SPEED WILL REMAIN ON UNTIL HEAT IS NO LONGER SENSED" will scroll in the display as a reminder. The vent fan is also the cooling fan, and will start at low speed when any non-sensor cooking function begins, or at medium speed when any sensor cooking function begins. It will remain on until the cooking function ends. To Turn Vent Fan On/Off: Touch VENT FAN pad once for high, twice for medium, 3 times for low or 4 times for off. The Timer can be set in minutes and seconds, up to 90 minutes, and counts down the set time. NOTE: The Timer does not start or stop the microwave oven. While the Timer is in use, the microwave oven can also operate. To see the countdown for 10 seconds while the microwave oven is in use, touch TIMER SET/OFE To Set: 1. Touch TIMER SET/OFE The TIMER icon will appear in the display. "ENTER TIME IN MIN AND SEC" will scroll in the display. If no action is taken after 2 minutes, the display will return to the time of day mode. 2= Touch the number pads to set the length of time. 3. Touch TIMER SET/OFF or START. When the set time ends, "END" will appear in the display, and end-of-timer tones will sound, followed by reminder tones. When reminder tones sound, "END TIMER" appears in the display. If tones are turned off, "OFF TIMER" will appear in the display as a reminder. Remember, touching CANCEL OFF while a cook function is active in the display will cancel the cook function, not the Timer. 4= Touch TIMER SET/OFF or CANCEL OFF to cancel the Timer when only the Timer is operating. Touch TIMER SET/OFF when a cook function is also operating to make the Timer countdown active in the display, and then touch CANCEL OFF to cancel the Timer. The cook function will continue to operate. The cooktop light has 3 settings: high, low and off. To Turn Light On/Off: Touch LIGHT pad once for high, twice for low or 3 times for off. The Demo Mode is ideal for learning how to use the microwave oven. When set, functions can be entered without actually turning on the microwave generator (magnetron). The microwave oven light will come on, the fan will run, and the turntable will rotate (if set on). The DEMO icon will appear in the display while the microwave oven is off, and will flash during any function. After 5 minutes of inactivity, a reminder message will scroll in the display when any control pad is touched. To Turn On/Off: The microwave oven must be in standby mode. Touch and hold the number pad "3" for 3 seconds until 2 tones sound and the DEMO icon appears in the display. Repeat to turn off and remove the DEMO icon from the display.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

Tones
areaudible
signals,
indicating
thefollowing:
One tone
Valid entry (short tone)
Two tones
End of timer countdown
End of stage in multistage
cooking
Control
Lock active
Hidden feature
has been entered
or exited
Reminder,
repeat each minute
after the end-of-cycle
tones
Three
tones
Invalid entry
Four tones
End of cycle
To Turn Off/On
Valid
Entry Tones:
With the microwave
oven in
standby
mode, touch
and hold the number
pad "1" for 3 seconds
until 2 tones sound. Touch and hold number
pad "1" to turn tones
back on.
To Turn Off All Tones (except
end-of-timer
and hidden
feature
tones):
With the microwave
oven in standby
mode, touch
and
hold the number
pad "2" for 3 seconds
until 2 tones
sound.
Touch and hold number
pad "2" to turn tones back on.
,4
_
_•
#"
+
Z"
The Control
Lock shuts
down the control
panel pads to prevent
unintended
use of the microwave
oven.
When the control
is locked, only the Vent Fan and Light pads will
function.
If any other control
pad is touched,
"LOCKED"
will
appear in the display
and the invalid entry tones will sound.
To Lock/Unlock
Control:
The microwave
oven must be in
standby
mode. Touch and hold CANCEL OFF for 3 seconds
until
2 tones sound and a padlock
icon appears
in the display.
Repeat
to unlock and remove the padlock
icon from display.
The vent (exhaust) fan has 3 speeds:
high, medium
and low.
To protect the microwave
oven, if the temperature
from the range
or cooktop
below the microwave
oven gets too hot, the vent fan
will automatically
turn on at low speed.
It may stay on for up to
1 hour to cool the microwave
oven. When this occurs,
the vent
fan cannot
be turned
off. If the vent fan pad is touched
during
automatic
fan operation,
"AUTO FAN IS ON, FAN SPEED WILL
REMAIN ON UNTIL HEAT IS NO LONGER SENSED" will scroll in
the display
as a reminder.
The vent fan is also the cooling
fan, and will start at low speed
when any non-sensor
cooking
function
begins, or at medium
speed when any sensor cooking
function
begins.
It will remain on
until the cooking
function
ends.
To Turn Vent Fan On/Off:
Touch VENT FAN pad once for high,
twice for medium,
3 times for low or 4 times for off.
The Timer can be set in minutes
and seconds,
up to 90 minutes,
and counts down
the set time.
NOTE:
The Timer does not start or stop the microwave
oven.
While the Timer is in use, the microwave
oven can also operate.
To see the countdown
for 10 seconds
while the microwave
oven
is in use, touch TIMER SET/OFE
To Set:
1.
Touch TIMER SET/OFE
The TIMER icon will appear
in the display.
"ENTER TIME IN MIN AND SEC" will scroll in the display.
If no
action is taken after 2 minutes, the display
will return to the
time of day mode.
2=
3.
Touch the number
pads to set the length of time.
Touch TIMER SET/OFF or START.
When the set time ends, "END" will appear
in the display, and
end-of-timer
tones
will sound, followed
by reminder tones.
When reminder tones sound,
"END TIMER" appears
in the
display.
If tones are turned
off, "OFF TIMER" will appear
in
the display
as a reminder.
Remember,
touching
CANCEL OFF while a cook function
is
active
in the display
will cancel
the cook function,
not the
Timer.
4=
Touch TIMER SET/OFF or CANCEL OFF to cancel
the Timer
when only the Timer is operating.
Touch TIMER SET/OFF when a cook
function
is also
operating
to make the Timer countdown
active in the display,
and then touch
CANCEL OFF to cancel
the Timer. The cook
function
will continue
to operate.
The cooktop
light has 3 settings:
high, low and off.
To Turn Light
On/Off:
Touch LIGHT pad once for high, twice
for
low or 3 times
for off.
The Demo Mode
is ideal for learning
how to use the microwave
oven. When set, functions
can be entered without
actually turning
on the microwave
generator
(magnetron).
The microwave
oven
light will come on, the fan will run, and the turntable
will rotate (if
set on).
The DEMO icon will appear
in the display
while the microwave
oven is off, and will flash during any function.
After 5 minutes
of
inactivity,
a reminder
message will scroll in the display
when any
control
pad is touched.
To Turn On/Off:
The microwave
oven must be in standby
mode.
Touch and hold the number
pad "3" for 3 seconds
until 2 tones
sound and the DEMO icon appears
in the display.
Repeat to turn
off and remove the DEMO icon from the display.