Whirlpool RF265LXTS Installation Instructions - Page 9

3-wire connection: Direct wire Use this method only if local codes permit connecting ground conductor to neutral supply wire. 1. Loosen (do not remove) the hex washer head screws and insert the neutral (white) wire under the screw clamp at the bottom of the center position terminal connector. D C E F B G A Verify Anti-Tip Bracket Location 1. Pull drawer open to first stop position. Lift front of drawer to clear white wheels in drawer guides. Remove drawer and set it aside on a protected surface. 2. Making sure the anti-tip bracket is installed: s Look for the anti-tip bracket securely attached to floor. s Slide range back so rear range foot is under anti-tip bracket. A. Line 1 B. Ground-link C. Hex washer head screw D. Silver-colored terminal block screw E. Neutral (white) wire F. Line 2 G. UL listed strain relief and power supply cable 2. Insert the other 2 wires (lines 1 and 2) under the other 2 screw clamps. B A 3. If installing the range in a mobile home, you must secure the range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the "Location Requirements" section. Level Range 1. Place rack in oven. Place level on rack and check levelness of range, first side to side; then front to back. A. Insert wire under screw clamp. B. Hex washer head screw 3. Securely tighten the hex washer head screws to 35 lbs-in. (4.0 N-m) minimum torque to make a proper electrical connection. 4. Tighten the locking ring of the conduit connector. 5. Replace the terminal block cover. If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket. On Ranges Equipped with Storage Drawers: Use ³⁄₈" drive ratchet and channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. On Ranges Equipped with Warming Drawers: Use channel lock pliers to adjust leveling legs up or down until range is level. Push range back into position. Check that rear leveling leg is engaged in anti-tip bracket. NOTE: Range must be level for satisfactory baking conditions. 2. Replace the storage drawer (and warming drawer on some models). 9