Whirlpool SF265LXTT Installation Instructions - Page 12
To Convert, Standard, Surface, Burners, LP Gas Orifice Spud Chart, Burner, Rating, Color, ID Number
UPC - 883049054919
View all Whirlpool SF265LXTT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
To Convert Standard Surface Burners 1. Remove burner cap. 2. Using a Phillips screwdriver, remove the burner base. NOTE: Reinstall one of the screws through the range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds. A. Igniter electrode B. Gas tube opening C. Burner cap D. Burner base 3= Apply masking tape to the end of a _A6"nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. LP Gas Orifice Spud Chart for Standard Surface Burners Burner Rating Color Size ID Number 12,000 BTU 11,000 BTU 8,000 BTU 5,000 BTU Green/Magenta Green/Yellow Green/Lt. Blue Green/Brown 1.03 mm 0.99 mm 0.80 mm 0.65 mm L103 L99 L80 L65 NOTE: Refer to the Model Number and Serial Number Plate located behind the left side of the storage or warming drawer for proper sizing of spuds for each burner location. 5. Place Natural gas orifice spuds in the cardboard orifice spud holder. 6. Replace the burner base using both screw. 7. Replace burner cap. 8. Repeat steps 1-7 for the remaining burners. To Convert Oven Bake Burner 1. Remove oven racks. 2. Use a 1/2"combination wrench to turn the orifice hood down snug onto pin (about 2 to 21/2turns). IMPORTANT: Do not overtighten. The oven bake burner flame cannot be properly adjusted if this conversion is not made. See "Adjust Oven Bake Burner Flame" section. A A. Orifice spud B. Orifice spud holder C. Screw D. Spark electrode 4= Remove the cardboard orifice spud holder located on the back of the range near the gas inlet. Gas orifice spuds are stamped with a number, marked with 1 color dot, and have a groove in the hex area. Replace the Natural gas orifice spud with the correct LP gas orifice spud. A. Orifice hood B. Pin C. Natural gas: increase gas - increase flame size (preset at factory for Natural gas) D. LP gas: decrease gas - decrease flame size To Convert Oven Broil Burner Use a 1/2"combination wrench to turn the orifice hood down snug onto the pin (about 2 to 2V_turns). IMPORTANT: Do not overtighten. The oven broil burner flame cannot be properly adjusted if this conversion is not made. See "Adjust Oven Broil Burner Flame" section. A. Groove Refer to the following chart for correct LP gas orifice spud placement. 12